Epson LW-K400 사용자 설명서 - 페이지 6
{카테고리_이름} Epson LW-K400에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson LW-K400 10 페이지.
Epson LW-K400에 대해서도 마찬가지입니다: 설정 매뉴얼 (2 페이지)
페이지 인쇄
LW-K400
User's Guide
Adding a frame
J
1. Press
.
2. Select an item with
Entering the frame No. to select does the same.
Available frames sSymbol List
Specifying the length of labels
J
1. Press
.
2. Highlight "Label length" using the cursor keys, then press
3. Select a value (up to 40 cm) using the cursor keys or enter the
value using the numeric keys, then press
4. Select a text alignment setting using the cursor keys, then press
.
5. Press
to confirm the font size setting.
6. Select "Auto" using the cursor keys, then press
7. Enter text.
If the length of entered text exceeds the label length you specified,
the font becomes small so that the entire text fits in the specified
length.
Changing the margins of labels
J
1. Press
.
2. Highlight "Margins" using the cursor keys, then press
3. Select one of the options using the cursor keys, then press
4. Press
.
If you select the "None" option, a cut mark is printed. Cut the tape
along the cut mark.
Adjusting the space between characters
J
1. Press
.
2. Select "Char. spacing" with
3. Select an item with
Making the width of font narrower
J
1. Press
.
2. Select "Narrow" with
3. Select "Narrow" with
Lining up characters vertically
J
1. Press
.
2. Select "Vertical" with
3. Select "On" with
Using mirror writing for the label
J
1. Press
.
2. Select "Mirror print" with
3. Select "On" with
, and press
.
.
.
.
, and press
.
, and press
.
, and press
.
, and press
.
, and press
.
, and press
.
, and press
.
, and press
.
Creating a label with a special form
To create labels with a special form, a message confirming that
c
the text will be deleted may appear when
to delete the current text and to show the special form.
MEMO
To exit the following special form mode, press
"Exit" and press
Creating an folder tab label
J
.
1. Press
.
2. Select from "Tab:Medium", "Tab:Small" or "Tab:Large" with
and press
3. Select a value with
Maximum length: 12.5cm (5.0 inch)
4. Enter text.
.
Creating a label for cables
J
Flag labels wrapping a cable
1. Press
.
2. Select from "Flag:Hori.", "Flag:Vert." or "Flag:Edge" with
and press
3. Select a value with
Maximum length: 12.5cm (5.0 inch)
4. Enter text.
Labels wrapping a cable
1. Press
.
2. Select "Wrap" with
3. Select a value with
Maximum length: 12.5cm (5.0 inch)
4. Enter text.
.
.
or enter label length, and press
.
or enter label length, and press
, and press
.
or enter label length, and press
is pressed. Press
, then select the
,
.
,
.
.
6