Epson OT-TB34 설치 매뉴얼

{카테고리_이름} Epson OT-TB34에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson OT-TB34 2 페이지.

The OT-TB34 is an exclusive tear bar for the TM-C3400 to cut wrist band rolls from

General Data Company, Inc. (GD wristbands) manually at the perforation.

This guide explains how to install the tear bar in the TM-C3400.

Installing the OT-TB34

Follow the steps below to install the tear bar on

the paper ejection table.

1. Unlock the paper ejection guide with a

fine-tipped object.

2. Slide the paper ejection guide to as

narrow a position as possible.

3. Pull the release lever to open the roll

paper cover.

Installation Guide

Paper ejection table

4. Insert two hooks of the tear bar into the

5. Insert the other two hooks into the

6. Make sure that the tear bar is fully

groove on the far side of the paper

ejection table.

groove on the near side.

inserted. If there is a gap between it and

the paper ejection table, press the bar

down to set it securely.

no gap

412390900

Printed in Japan

no gap