Epson OT-TB34 Installatiehandleiding

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Epson OT-TB34. Epson OT-TB34 2 pagina's.

Pagina afdrukken
The OT-TB34 is an exclusive tear bar for the TM-C3400 to cut wrist band rolls from
General Data Company, Inc. (GD wristbands) manually at the perforation.
This guide explains how to install the tear bar in the TM-C3400.
Installing the OT-TB34
Follow the steps below to install the tear bar on
the paper ejection table.
1. Unlock the paper ejection guide with a
fine-tipped object.
2. Slide the paper ejection guide to as
narrow a position as possible.
3. Pull the release lever to open the roll
paper cover.
© 2012 Seiko Epson Corporation. All rights reserved.
Installation Guide
Paper ejection table
4. Insert two hooks of the tear bar into the
5. Insert the other two hooks into the
6. Make sure that the tear bar is fully
groove on the far side of the paper
ejection table.
groove on the near side.
inserted. If there is a gap between it and
the paper ejection table, press the bar
down to set it securely.
no gap
412390900
Printed in Japan
no gap