Epson 4880 - Stylus Pro Color Inkjet Printer 제품 정보 매뉴얼 - 페이지 11

{카테고리_이름} Epson 4880 - Stylus Pro Color Inkjet Printer에 대한 제품 정보 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 4880 - Stylus Pro Color Inkjet Printer 16 페이지. Ink fill for the refillable cartridge system
Epson 4880 - Stylus Pro Color Inkjet Printer에 대해서도 마찬가지입니다: 빠른 시작 설치 매뉴얼 (1 페이지), 네트워크 매뉴얼 (46 페이지), 설치 매뉴얼 (4 페이지), 제한 보증 (12 페이지), 사용 지침 (5 페이지)

페이지 인쇄

Epson 4880 - Stylus Pro Color Inkjet Printer 제품 정보 매뉴얼

9. When the uni-directional alignment is finished, press

until you see

BI-D 2-COLOR

to start the bi-directional black alignment process, which is

also completely automatic and takes about 7 minutes.

10. When the bi-directional black alignment is finished, press

until you see

BI-D ALL

start the alignment process. Again, this process is completely

automatic and takes about 17 minutes.

11. When done, press the

alignment mode.

If you want to verify or fine-tune the automatic alignment

process, you can perform a manual head alignment. See your

on-screen User's Guide for instructions.

Replacing the Paper Cutter Blade

If you notice that your paper isn't being cut cleanly, the cutter

blade may need to be replaced. If you use the blade to cut

heavy stock, you will damage the blade and need to replace it.

See the Printer Guide for a list of media that should not be cut

by the cutter.

Note: You can purchase replacement blades from an Epson

Professional Imaging authorized reseller. To find the nearest

reseller, visit www.proimaging.epson.com (U.S. sales),

www.epson.ca (Canadian sales), or call 800-GO-EPSON (800-463-

7766). Or you can purchase online at www.proimaging.epson.com

(U.S. sales) or www.epson.ca (Canadian sales).

You can check the status of your cutter by printing the status

check sheet or viewing its status on the control panel. See

page 8 for instructions.

You can obtain a new cutter blade from Epson (part number

C12C815291).

Make sure the printer is on, then follow these steps to replace

the blade:

1. Press the

button.

2. Press the

button until you see

3. Press

to display

Caution: Do not try to slide the carriage by hand, or you may

damage the printer.

4. Press

again. The print head moves to the cutter

replacement position.

OPEN TOP COVER

. Then press

again to

pause button to exit the head

CUTTER REPLACE

EXEC

is displayed.

5. Open the top cover.

again

6. When

REPLACE CUTTER

down the side pin as shown and turn the latch to the right.

7. Release the side pin and carefully remove the cutter blade.

WARNING: The blade is sharp. Be careful when removing it.

8. Insert the new cutter as shown.

12/07

Epson Stylus Pro 4880

is displayed on the LCD, hold