Epson C11C546011-N - Stylus Photo R200 사용자 설명서 - 페이지 4
{카테고리_이름} Epson C11C546011-N - Stylus Photo R200에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson C11C546011-N - Stylus Photo R200 12 페이지. User manual (p.i.m plug-in)
Epson C11C546011-N - Stylus Photo R200에 대해서도 마찬가지입니다: 보충 설명서 (1 페이지), 여기에서 시작하기 매뉴얼 (9 페이지), 사용자 설명서 (12 페이지)
페이지 인쇄
EPSON Stylus Photo R200
Replacing an Ink Cartridge
When the red H ink light flashes, one or more ink cartridges
are low on ink.
When the red H ink light stays on, you need to replace the
cartridge(s).
Ink light
When you print, you'll also see a message on your screen
telling you which cartridge is low or empty.
When a cartridge is more than six months old, you may need
to replace it if printouts don't look their best. If the quality
doesn't improve after cleaning and aligning the print head,
you can replace the cartridge even if the red H ink light is off.
Checking the Ink Supply
To check the ink supply, do one of the following:
❏ Windows: Double-click the
taskbar.
You see a window like this one:
❏ Macintosh OS X: Choose
>
Utility
SP R200 Series
❏ Macintosh OS 8.6 to 9.x: From the File menu, select
then click the
ink icon.
EPSON Stylus Photo R200
4 -
icon on the Windows
>
Applications
EPSON Printer
>
EPSON StatusMonitor
You see a window like this one:
Click a cartridge image to display information about the
cartridge.
Ink Cartridge Precautions
Warning: Keep ink cartridges out of the reach of children.
If ink gets on your hands, wash them thoroughly with soap and
water. If ink gets in your eyes, flush them thoroughly with water.
Caution: To avoid damaging the printer, never move the print head
by hand.
You cannot print if an ink cartridge is empty. Leave the empty
cartridge installed in the printer until you have obtained a
replacement. Otherwise the ink remaining in the print head nozzles
may dry out.
Removing and Installing Ink Cartridges
Be sure you have a new ink cartridge before you begin. Once
you start replacing a cartridge, you must complete all the steps
in one session.
1. Make sure the printer is turned on (the green P power light
should be on, but not flashing). Then open the printer
cover.
2. Press and release the H ink button.
If your ink light is off, go to step 4.
If your ink light is on or flashing, the print head moves to
the left, and the cartridge that need to be replaced stops
under the _ ink out mark. The
.
P power light begins to flash. Go to step 3.
,
Print
3. Press the H ink button again.
❏ If more than one cartridge is empty, the next cartridge
moves under the _ ink out mark.
❏ If all the empty cartridges have been identified, the print
head moves to the ink cartridge replacement position.
11/03