Epson EMP Monitor 운영 매뉴얼 - 페이지 30

{카테고리_이름} Epson EMP Monitor에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson EMP Monitor 37 페이지. Emp monitor for projectors
Epson EMP Monitor에 대해서도 마찬가지입니다: 운영 매뉴얼 (11 페이지), 운영 매뉴얼 (12 페이지), 사용자 설명서 (42 페이지), 운영 매뉴얼 (34 페이지), 운영 매뉴얼 (14 페이지)

페이지 인쇄

Using the control functions

The line colors in the Timers list have the following meanings:

Current day's timer setting

When some of the projectors in the group have timer setting enabled

and others have it disabled for the current day's timer setting

When the current day's timer setting is a disabled setting

Timer setting for a day other than the current day

The details that can be checked and operations that can be carried out

at this time are given below.

Selects a group or projector to check the status of.

Projectors

When a group is selected, the timer setting statuses for all

projectors in that group are displayed.

Shows the current day in a red box.

Date

Days for which timer settings have been made are shown in bold.

Click

next month.

Shows a list of the timer settings.

Timers

Switches the timer settings that have been selected from the

Enabled/

timer list between enabled and disabled.

disabled

Add

Registers new timer settings. s "Procedures for new timer

settings"

p.30

Edit

Lets you change the timer settings that have been selected from

the timer list. If a group has been selected for status checking,

the settings cannot be changed.

Lets you delete timer settings that have been selected from the

Delete

timer list.

to switch to the calendar for the previous or

Procedures for new timer settings

Procedure

Click "Add" on the timer setting window. The following

window is displayed and the new timer settings are applied.

At Operation, you can carry out the operations of turning the

power on and off and switching the input sources, similarly for

the control buttons on the main window. If you set the input

source switching, the projector's power will turn on at the timer

start time even if it is not on at the time. Because of this, it is

not necessary to make two separate timer settings for turning the

power on and switching the input source.

After completing the timer settings, click "OK".

The timer settings that have been made will be registered and

they can be checked in the displayed timer list.

You can enable and disable all of the timer settings that have been

registered. Select Timer - Enable or Disable from the Tool menu.