Epson FX-1180 - Impact Printer 빠른 매뉴얼 - 페이지 12

{카테고리_이름} Epson FX-1180 - Impact Printer에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson FX-1180 - Impact Printer 33 페이지. Epson serial impact dot matrix printers
Epson FX-1180 - Impact Printer에 대해서도 마찬가지입니다: 설정 매뉴얼 (33 페이지), 브로셔 및 사양 (24 페이지), 제품 정보 (17 페이지), 빠른 참조 매뉴얼 (16 페이지), 매뉴얼 (11 페이지), 사양 (2 페이지), 매뉴얼 (18 페이지), 사양 (2 페이지), 제한 보증 (1 페이지), 참조 매뉴얼 (34 페이지)

페이지 인쇄

6. Remove the front cover by pushing it

straight down, as shown below.

7. Make sure your paper has a clean,

straight edge. Then open both sprocket

covers and fit the first four holes of the

paper, with printable side up, over the

tractor pins.

8. Close the sprocket covers.

9. Slide the right sprocket to remove any

slack in the paper; then lock it in place by

pushing the sprocket lock down.

Downloaded from:

http://www.usersmanualguide.com/

EPSON FX-880+/FX-1180+ Quick Guide

10. Attach the front cover with the

continuous paper positioned as shown

below.

11. Make sure the paper guide is lying flat

on the printer and the edge guides are

open all the way to the left and right.

Then raise the continuous paper

support.

12. Turn on the printer. When the printer

receives data, it automatically loads the

paper and starts printing.

If the first line on your page appears too high

or low, you can change its position by using

the Micro Adjust function as described in

"Micro Adjust Function."

Caution:

Never use the knob to adjust the

top-of-form position; this may damage the

printer or cause it to lose the top-of-form

position.

Continuous Paper with the Front Push Tractor (2/2)