Dimplex BF36ST 서비스 매뉴얼 - 페이지 12
{카테고리_이름} Dimplex BF36ST에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex BF36ST 13 페이지. Optiflame electric fireplace
Dimplex BF36ST에 대해서도 마찬가지입니다: 설치 매뉴얼 (10 페이지)
페이지 인쇄
Troubleshooting Guide
PROBLEM
General
Circuit breaker trips or fuse
blows when unit is turned on
Unit turns on or off by itself
Appearance
Fireplace does not turn on
Manually
Fireplace does not turn on with
remote control (if applicable)
Flame Frozen
Flame not bright or flame not
visible
Log set dim, ember bed not
glowing
Flame Shudder
Light leaking around the log set
CAUSE
Short in unit wiring.
Improper circuit current rating
Remote Control has a similar frequency to
other remotes in the area.
Radio frequency disturbance from outside
sources.
Defective Remote Control Receiver
Improper operation
No incoming voltage from the electrical wall
socket/Breaker Panel
Loose wiring
Defective On/Off Switch
Defective Heater Switch
Defective Remote Control Receiver (If ap-
plicable)
Improper operation
Remote control not initialized to fireplace
Defective remote control
Defective Remote Control Receiver
Defective flicker motor
Loose wiring
Burnt light bulbs
Loose wiring
Defective light harness
Burnt light bulbs
Defective flicker motor
Log set not positioned properly
Trace wiring in unit.
Verify unit is installed on a dedicated 15 amp circuit.
Replace Remote Control
Replace remote control and Remote Control Receiver
Kit, where necessary.
Replace Remote Control Receiver
Refer to Operation Section
Check Fuse/Breaker Panel
Check wiring connections
Replace On/Off Switch
Replace Heater Switch
Replace Remote Control Receiver
Refer to Operation Section
Initialize the remote control
Install new battery into the remote control. Reinitilize
remote where necessary
Replace Remote Control and reinitialize
Replace Remote Control Receiver
Replace flicker motor
Check wiring connections
Replace light bulbs
Check wiring connections
Replace light harness
Replace light bulbs
Replace flicker motor
Check log set for proper fit
12
SOLUTION