Dimplex BLF74 서비스 매뉴얼 - 페이지 8

{카테고리_이름} Dimplex BLF74에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex BLF74 16 페이지. Section 10309 manufactured electric fireplaces
Dimplex BLF74에 대해서도 마찬가지입니다: 사용자 설명서 (3 페이지)

페이지 인쇄

Figure 5

wood flooring), it is recommended that a protective barrier

be used underneath, (i.e. cloth, cardboard, thick plastic).

5. Proceed to the instructions within this manual relating

to the repair being performed - see Table of Contents

for page number.

6. Once repair is complete, reassemble in the reverse

order as above.

Flush Mount – Complete In-wall

(Figure 7)

Tools Required: Philips head screwdriver

CAUTION: Follow "Preparation for Service" instructions

before proceeding.

1. Remove the decorative glass ember-bed pieces from

the media tray, which lies along the bottom of the

interior Partially Reflective Glass. A medium sized

container such as a bucket or a box will be needed to

keep the glass ember-bed pieces together.

2. Locate and remove the 4 mounting screws inside the

unit located on left and right side towards the front.

There are 2 screws per side, going from the side

panels out into the side of the wall stud that frames the

Figure 6

fireplace. (Figure 7)

CAUTION: The unit should be supported while remov-

ing the screws to prevent the unit from falling.

Remove the fireplace out of the opening by slightly lift-

ing and pulling forward.

4. Carefully lay the unit down on a solid flat surface with

the front of the unit facing up.

NOTE: If the surface you are using as a work area is

a finished surface that is prone to scratches (i.e. hardwood

flooring), it is recommended that a protective barrier be

used underneath, (i.e. cloth, cardboard, thick plastic).

5. Proceed to the instructions within this manual relating

to the repair being performed - see Table of Contents

for page number.

6. Once repair is complete, reassemble in the reverse

order as above.

ON/OFF SWITCH REPLACEMENT

WARNING: Disconnect power before attempting any

maintenance or cleaning to reduce the risk of electric

shock or damage to persons.

CAUTION: If unit was operating prior to servicing allow

at least 10 minutes for lights and heating elements to cool

off to avoid accidental burning of skin.

Tools required: Phillips head screwdriver.

Needle nosed pliers.

CAUTION: Follow "Preparation for Service" instructions

before proceeding.

1. Remove the 2 screws, that secure the controls assem-

bly (Figure 8), located at the top of the mirror on the

right side of the unit.

Figure 7

Wall Surface

Mounting Hole