Dimplex BLF7451-AU 사용 설명서 - 페이지 14

{카테고리_이름} Dimplex BLF7451-AU에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex BLF7451-AU 19 페이지. Prism 1.2kw wall mounted electric fire
Dimplex BLF7451-AU에 대해서도 마찬가지입니다: 소유자 매뉴얼 (19 페이지)

페이지 인쇄

Installation

Flush Mount- see Fig. 9 & 10

CAUTION: Two people will be required for various steps of this procedure.

1. Prepare a wall with a framed opening for the correct model (Fig. 9)

• 34" Model: 83.8cm wide x 47cm high

• 50" Model : 124.5cm wide x 47cm high

• 74" Model: 185.4cm wide x 47cm high

NOTE: It is recommended that the bottom of the unit not be mounted higher than

102cm from the ground to maintain an optimized viewing angle of the flame.

WARNING: Do not attempt to wire your own new outlets or circuits. To reduce the risk

of fire, electric shock or injury to persons, always use a licensed electrician.

WARNING: Ensure that the circuit on which the fireplace is to be installed has the

power cut off at the service panel until installation is complete.

2. Lift fireplace and insert into opening. The fireplace's mounting trim should be flush

against the wall (Fig. 10).

3. Use the supplied spirit level to level the fireplace within the framing, adjust as

required.

4. Drive four supplied mounting screws through the four mounting holes located on the

inside surface of the fireplace chassis, into wall studs (Fig. 10).

5. Refer to Front Glass Installation section for final installation procedures.

Operation

User Modes:

Mode Name /

Description

Change Celsius

(

C) to Fahrenheit

(

Disable / Enable

Heat Options

Action (Actions cannot be input by remote control)

Press both 3 Dot Button ( ) and 2 Dot ( ) on the unit and hold

until beep is heard and display flashes. (To revert back to Celsius

repeat this action)

Hold both 1 Dot Button ( ) and Flame Button ( ), on the unit, for

2 seconds, when the heater has been disabled the display will read

"--" and beep. To enable heat repeat this action.