Dimplex BLF7451-AU 사용 설명서 - 페이지 12

{카테고리_이름} Dimplex BLF7451-AU에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex BLF7451-AU 19 페이지. Prism 1.2kw wall mounted electric fire
Dimplex BLF7451-AU에 대해서도 마찬가지입니다: 소유자 매뉴얼 (19 페이지)

페이지 인쇄

Installation

Surface Mounting (34" & 74" Models)- see Fig. 3 & 4

CAUTION: Two people will be required for various steps of this procedure.

1. Determine the mounting location of the unit so that the wall-mounting bracket can

be installed into a minimum of 2 wall studs for the 34" Models and 4 wall studs for

the 74" Models

NOTE: It is recommended that the mounting bracket be installed 142cm off of the

ground to maintain an optimized viewing angle of the flame.

2. Hold the wall mounting bracket, with the spirit level on the top, on the wall so that

the bubble on the level is centered between the two black lines.

3. Mark the 4 mounting screw locations, on the wall, ensuring that the wall bracket

stays level (Fig. 3) marked (A).

4. In locations where the screws are being installed only into drywall, install the supplied

wall anchors before installing the screw (pre-drill if required).

5. Secure the wall bracket to the wall using the supplied 3.8 cm mounting screws and

washers into the wall and/or wall anchors.

6. Install the bottom support bracket to the wall centered with the wall mounting

bracket, using the appropriate mounting hardware, 350mm below the wall mounting

bracket (Fig. 3) marked (B).

7. Remove the center screw from the bottom of the fireplace. (Fig. 4)

8. Hang the fireplace from the bracket.

9. Install the previously removed screw through the bottom support bracket into the

fireplace.

10.

Refer to Front Glass Installation section for final installation procedures.

Surface Mounting (50" Models) - see Fig. 5 & 6

CAUTION: Two people may be required for various steps of this procedure.

1. Choose a location which has a minimum of two wall studs available for mounting.

2. Remove the partially reflective glass from the fireplace:

• Lay fireplace on its back.

• Remove two Phillips screws from each of the two glass brackets (Fig. 5) marked

(A).

• Remove glass brackets (Fig. 5) marked (B).

• With one hand keeping pressure on the partially reflective glass, tilt the fireplace

upright and slightly forward to allow the partially reflective glass to fall out of the

inside framing.

CAUTION: Partially reflective glass is not tempered. Do not bump or drop the partially

reflective glass to avoid breakage and personal injury.

• Remove partially reflective glass from fireplace.