Epson PowerLite 82c 빠른 설정 매뉴얼 - 페이지 2

{카테고리_이름} Epson PowerLite 82c에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson PowerLite 82c 7 페이지. Projector
Epson PowerLite 82c에 대해서도 마찬가지입니다: 사용자 설명서 (42 페이지), 사양 시트 (15 페이지), 운영 매뉴얼 (47 페이지), 부품 목록 (1 페이지), 설치 매뉴얼 (19 페이지), 제품 지원 게시판 (25 페이지), 제품 지원 게시판 (8 페이지), 제품 지원 게시판 (22 페이지), 제품 지원 게시판 (28 페이지), 적합성 선언 (4 페이지), 제품 지원 게시판 (41 페이지), 제품 지원 게시판 (15 페이지), 제품 지원 게시판 (22 페이지), 사양 (2 페이지), 사양 (2 페이지)

Connect your video source

The projector has 4 video connectors, as shown below. Each one requires a

different type of cable. A computer cable is included. You can purchase optional

video cables through Epson or at local electronics stores. You can connect up

to 4 video devices and use the remote control to switch among them.

Check the connectors on your video equipment. If more than one

connection is available, choose the one that provides the best quality.

The projector connectors from highest to lowest quality are

Computer1(Component) or Computer2(Component), S-Video,

and Composite Video.

Make sure you have the right cable(s) for the connection(s) you want

to use, and the cables are long enough for your setup. If you need

a cable longer than the standard 6 to 10 feet, you may need a

distribution amplifier. (See the back page for accessory information.)

Before you connect your equipment, make sure everything is turned off.

Connect your video equipment to the projector.

Component

video to

VGA cable

NOTE

To play back audio through the projector, you can connect an audio

cable from your video device to the audio in ports on the projector.

See the User's Guide on your CD-ROM for instructions.

Set up the remote control

Remove the battery cover.

Insert the batteries.

Replace the battery cover.

The remote control is ready for use.

Computer

cable

S-Video

cable

(included)

RCA video cable

(composite

video)

Audio in ports