Epson Stylus COLOR 3000 사용자 설명서 - 페이지 16

{카테고리_이름} Epson Stylus COLOR 3000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Stylus COLOR 3000 43 페이지. Epson stylus color 3000: product information
Epson Stylus COLOR 3000에 대해서도 마찬가지입니다: 사용자 설명서 (34 페이지), 사용자 설명서 (38 페이지), 브로셔 및 사양 (24 페이지), 빠른 설정 매뉴얼 (21 페이지), 브로셔 및 사양 (2 페이지), 사양 (1 페이지), 매뉴얼 (13 페이지), 브로셔 및 사양 (4 페이지)

페이지 인쇄

Preparing for Standalone Installation

If you connected the printer to a standalone Macintosh, you

need to make AppleTalk active. Open the Chooser in the Apple

menu and make sure AppleTalk is active.

You must set your Network Control Panel to Remote only if

you've connected your printer in one of these configurations:

You're using System 7.51 or lower and have connected the

printer to the printer port on your Macintosh

You're using System 7.52 or higher and have connected the

printer to the modem or printer port on your Macintosh

and do not have an optional interface card installed

For other configurations, go to "Installing on a Standalone or

Print Server System" on the next page.

Follow these steps to set up the printer as Remote only:

1. Restart your Macintosh with all extensions turned off

except your CD-ROM drive. Then turn on your printer.

2. Insert the StylusRIP CD-ROM in the CD-ROM drive.

3. Locate the Extensions folder within the System folder on

your hard disk drive.

4. Drag the

Remote Only

System Extensions folder.

5. From the Apple menu, open the Control Panels utility.

Click the

Network

system uses the Open Transport protocol, there is no

icon; in this case, open the AppleTalk folder and

Network

select

Remote Only

Installing the StylusRIP Software

file from the CD-ROM to the

icon and select

Remote Only

in the

Connect via

1-3

. (If your

list box.)