Epson Stylus COLOR 3000 Gebruikershandleiding - Pagina 16

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Epson Stylus COLOR 3000. Epson Stylus COLOR 3000 43 pagina's. Epson stylus color 3000: product information
Ook voor Epson Stylus COLOR 3000: Gebruikershandleiding (34 pagina's), Gebruikershandleiding (38 pagina's), Brochure & specificaties (24 pagina's), Handleiding voor snelle installatie (21 pagina's), Brochure & specificaties (2 pagina's), Specificaties (1 pagina's), Handmatig (13 pagina's), Brochure & specificaties (4 pagina's)

Preparing for Standalone Installation

If you connected the printer to a standalone Macintosh, you

need to make AppleTalk active. Open the Chooser in the Apple

menu and make sure AppleTalk is active.

You must set your Network Control Panel to Remote only if

you've connected your printer in one of these configurations:

You're using System 7.51 or lower and have connected the

printer to the printer port on your Macintosh

You're using System 7.52 or higher and have connected the

printer to the modem or printer port on your Macintosh

and do not have an optional interface card installed

For other configurations, go to "Installing on a Standalone or

Print Server System" on the next page.

Follow these steps to set up the printer as Remote only:

1. Restart your Macintosh with all extensions turned off

except your CD-ROM drive. Then turn on your printer.

2. Insert the StylusRIP CD-ROM in the CD-ROM drive.

3. Locate the Extensions folder within the System folder on

your hard disk drive.

4. Drag the

Remote Only

System Extensions folder.

5. From the Apple menu, open the Control Panels utility.

Click the

Network

system uses the Open Transport protocol, there is no

icon; in this case, open the AppleTalk folder and

Network

select

Remote Only

Installing the StylusRIP Software

file from the CD-ROM to the

icon and select

Remote Only

in the

Connect via

1-3

. (If your

list box.)