3Com 3CRWE675075 - 11a/b/g Wireless LAN Workgroup Bridge 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} 3Com 3CRWE675075 - 11a/b/g Wireless LAN Workgroup Bridge에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com 3CRWE675075 - 11a/b/g Wireless LAN Workgroup Bridge 9 페이지. 11a/b/g wireless workgroup bridge

3Com 3CRWE675075 - 11a/b/g Wireless LAN Workgroup Bridge 빠른 시작 매뉴얼
4

Checking the LED Indicators

When the Bridge is connected to power, LEDs indicate activity as follows (solid LED indicates connection;
blinking LED indicates activity):
5

Attaching An External Antenna

The Bridge has two internal diversity dual-band antennas. If you want to increase the range of the
Bridge, an external antenna can be attached to the external antenna connector on the Bridge. The
3Com-approved external antenna for this Bridge is the 3Com 2.4/5 GHz Omnidirectional Workgroup
Bridge Antenna (3CWE501). For more information, go to www.3Com.com
6

Determining if you Need to Configure the Bridge

If your network has a DHCP server and no special security requirements, you can most likely use the
Bridge just as it is shipped from the factory. View the Bridge's default settings on the next page to
determine whether or not you need to configure the Bridge for your network.
It takes about one to two minutes for the Bridge to determine if there is a DHCP server on the network.
If your network does not have a DHCP server or is more complex, you will want to configure the Bridge
and organize devices so that you can manage the wireless LAN easily and keep it secure.
CAUTION: For non-U.S. versions of the Bridge, you need to set the Country mode. This is done
when you first open the Bridge's Configuration Management System. Select the Country in which
the Bridge is operating and then click Apply.
LED
Color
Power
Green
Off
11a
Green
Off
11g
Green
Off
100
Green
Off
10
Green
Off
Indicates
The Bridge is powered up
and operating normally.
The Bridge is not receiving
power or there is a fault with
the power supply.
The Bridge has WLAN frame
transmission over the
802.11a 5 GHz radio band.
No link is present.
The Bridge has WLAN frame
transmission over the
802.11g 2.4 GHz radio band.
No link is present.
The Bridge has a 100 Mbps
Fast Ethernet connection.
No link is present.
The Bridge has a 10 Mbps
Ethernet connection.
No link is present.