3Com 3CRWE675075 - 11a/b/g Wireless LAN Workgroup Bridge 빠른 시작 매뉴얼 - 페이지 4
{카테고리_이름} 3Com 3CRWE675075 - 11a/b/g Wireless LAN Workgroup Bridge에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com 3CRWE675075 - 11a/b/g Wireless LAN Workgroup Bridge 9 페이지. 11a/b/g wireless workgroup bridge
페이지 인쇄
3
Connecting the Bridge
Before connecting the Bridge to an Ethernet client, connect the power supply. The figure below shows
the ports for connecting the power and Ethernet cables.
The bridge can also be connected to a serial device. Serial cables come with a variety of connector sizes.
If your connector is large and prevents the cradle from being attached to the Bridge, remove the end cap
on the cradle. This allows the connector to extend through the cradle.
Connecting to an Ethernet Device
The Bridge is designed to be connected to an Ethernet client device such as a hub, computer, or printer.
CAUTION: To avoid the possibility of a transmission loop situation between the Bridge and
an access point, which could disrupt network operation, do not connect a Bridge that is set
in Wireless Client (Infrastructure) mode directly to the LAN (for example, through a wall
port or through a hub that is connected directly to the LAN).
Connecting to a Hub
You can supply network connections for up to 16 devices, such as computers and network printers, by
connecting the Bridge to an Ethernet hub, as shown below.
P ower
C able
A ccess
P oint
ET
ET
R
R
SS
SS
HE
HE
RN
RN
WE
WE
LE
LE
ET
ET
PO
PO
WI
WI
RE
RE
E thernet
C able
H ub
U plink P ort
11 a / b / g W ireless
W orkgroup B rid ge