3Com 3CRWE675075 - 11a/b/g Wireless LAN Workgroup Bridge 빠른 시작 매뉴얼 - 페이지 3
{카테고리_이름} 3Com 3CRWE675075 - 11a/b/g Wireless LAN Workgroup Bridge에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com 3CRWE675075 - 11a/b/g Wireless LAN Workgroup Bridge 9 페이지. 11a/b/g wireless workgroup bridge
페이지 인쇄
Wall-mounting the Bridge
The Bridge comes equipped with a cradle for mounting on a wall. For additional security, the Bridge also
comes with a locking bar, which can be used with a security lock (not provided) to lock the Bridge to the
cradle after the Bridge is mounted to the wall.
To wall-mount the Bridge:
1
Screw the cradle to a wall.
2
Route the power and Ethernet cables through the large opening in the cradle.
The figures below show the cradle being mounted to a wall, and then a cable being routed
through the large opening in the cradle.
C radle
Wall-mounting the cradle
3
Connect the power and Ethernet cables to the ports on the front of the Bridge.
4
Snap the Bridge onto the cradle.
To install the locking bar, push the locking bar through the opening in the side of the cradle until the
hole on the locking bar is exposed. Insert a lock (not provided) through the hole on the locking bar,
and then close the lock to secure it in place. See the user guide for detailed instructions.
Inserting the locking bar
Placing the Bridge on a Flat Surface
To install the Bridge on a flat surface such as a table or desktop, remove the backing from the four
rubber feet and attach them on the bottom of the cradle.
CAUTION: Do not place the Bridge on any type of metal surface. Select a location that is clear
of obstructions and provides good reception.
Routing a cable
Securing the bar with a lock