Epson Stylus Pro 9600 Photographic Dye Ink 포장 풀기 및 설정 매뉴얼 - 페이지 15

{카테고리_이름} Epson Stylus Pro 9600 Photographic Dye Ink에 대한 포장 풀기 및 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Stylus Pro 9600 Photographic Dye Ink 24 페이지. Large format digital colour printing
Epson Stylus Pro 9600 Photographic Dye Ink에 대해서도 마찬가지입니다: 브로셔 및 사양 (24 페이지), 정보 매뉴얼 (16 페이지), 부품 목록 (21 페이지), 빠른 설치 매뉴얼 (34 페이지), 제품 정보 (15 페이지), 빠른 참조 매뉴얼 (11 페이지), 브로셔 및 사양 (8 페이지), 브로셔 및 사양 (6 페이지), 브로셔 및 사양 (16 페이지), 제품 참조 매뉴얼 (28 페이지), 사양 (4 페이지), 수동 업데이트 (4 페이지)

Setting up Stylus Pro 7600/9600

Connecting the power cord

1. Make sure that the printer is off. It is off when

the surface of the Power button is even with

the button protectors.

2. Connect the power cord to the AC inlet on the

back of the printer.

3. Route the power cord through the clamps at

the rear of the printer. The cord can be routed

to either the left or right side.

4. Check the label on the back of the printer to

make sure the voltage required by the printer

matches that of the electrical outlet you are

using.

5. Plug the power cord into a properly grounded

electrical outlet.

Caution:

Do not use an outlet that is controlled by an

automatic timer or wall switch. Otherwise,

accidental shut down or damage to your

printer may occur.

Installing the ink cartridges

To install the ink cartridges, follow the

instructions below.

Warnings:

The ink cartridges are self-contained units.

Under ordinary use, ink will not leak from the

cartridges. If ink does get on your hands, wash

them thoroughly with soap and water. If ink gets

into your eyes, flush them immediately with

water.

1. Turn on the printer by pressing the Power

button. After a short time NO INK CARTRIDGE

is displayed on the LCD panel.

2. Open the ink compartment cover, and make

sure that the ink lever is in the up position.

3. Remove the package from an ink cartridge.