Epson Stylus Pro 9600 Photographic Dye Ink 포장 풀기 및 설정 매뉴얼 - 페이지 16

{카테고리_이름} Epson Stylus Pro 9600 Photographic Dye Ink에 대한 포장 풀기 및 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Stylus Pro 9600 Photographic Dye Ink 24 페이지. Large format digital colour printing
Epson Stylus Pro 9600 Photographic Dye Ink에 대해서도 마찬가지입니다: 브로셔 및 사양 (24 페이지), 정보 매뉴얼 (16 페이지), 부품 목록 (21 페이지), 빠른 설치 매뉴얼 (34 페이지), 제품 정보 (15 페이지), 빠른 참조 매뉴얼 (11 페이지), 브로셔 및 사양 (8 페이지), 브로셔 및 사양 (6 페이지), 브로셔 및 사양 (16 페이지), 제품 참조 매뉴얼 (28 페이지), 사양 (4 페이지), 수동 업데이트 (4 페이지)

페이지 인쇄
Epson Stylus Pro 9600 Photographic Dye Ink 포장 풀기 및 설정 매뉴얼
Note:
If you use the EPSON UltraChrome ink cartridge,
shake the cartridge gently before installing it.
4. Hold the ink cartridge with arrow mark on the
left side and pointing to the rear of the printer,
and insert it into the slot until the
corresponding Ink Out light turns off.
5. Repeat step 4 for the other six color ink
cartridges.
6. After inserting all ink cartridges into each slot,
set the ink lever in the down position.
7. Close the ink compartment cover.
After installing all seven ink cartridges, the printer
begins charging the ink delivery system and the
Pause light flashes (for about 7 minutes). When the
ink delivery system is charged, the Pause light
stops flashing.
c
Caution:
Never do the following while the Pause light is
flashing; other wise damage may occur:
Turn off the printer
Open the front cover
Set the ink lever in the up position
Move the paper lever to the released
position
Unplug the power cord
14
Loading the Roll Paper
To load the roll paper onto the printer, follow the
instructions below.
1. Slide the movable flange off the end of the
spindle.
2. Place the roll paper on a flat surface so that it
unwinds in the direction shown. Slide the roll
paper onto the spindle and fully onto the fixed
flange.
3. Slide the movable flange back onto the spindle
until it fixes into place in the end of the roll
paper.
4. Open the roll paper cover. Holding the
spindle, fit the left and right ends of the
spindle into the mounting brackets inside the
printer.
Note:
The spindle and mounting brackets are color-coded.
Mount the spindle into the mounting bracket that is the
same color as the end of the spindle.
5. Make sure that the printer is turned on, then
repeatedly press the Paper Source button
until the Roll Auto Cut light comes on.