Toshiba e-STUDIO7516AC 사용자 설명서 - 페이지 14
{카테고리_이름} Toshiba e-STUDIO7516AC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba e-STUDIO7516AC 20 페이지. Sys board diagnosis tool
Toshiba e-STUDIO7516AC에 대해서도 마찬가지입니다: 관리 매뉴얼 (32 페이지), 운영자 매뉴얼 (32 페이지)
페이지 인쇄
No.
Inspection item
12
SATA I/F &
SMART
13
USB Host
14
USB Fax
15
Scan Control
16 LGC
Communication
17
SLG
Communication
*1. Here shows the
installed status of
the DF (No
ADF, RADF,
DSDF)
*2. Although it may
be displayed as
"WARMUP", it is
reference
information.
(Continued on next page)
Inspection result
NG [LINK DOWN]
NG [SPD]
NG [SMART]
NG [ID]
OK?
OK?
OK? [No fax
detected]
NG
NG
NG [LGC_EN]
NG [C900]
NG [C963]
NG [LGC_Reset] Replace the SYS board.
NG<DF*1>*2
NG <DF *1>
[SLG_EN] *2
NG <DF*1>
[C260] *2
NG <DF*1>
[C261] *2
NG <DF*1>
[C262] *2
NG <DF*1>
[C270] *2
14
Correspondence
Step 1. Check the installation status of the
HDD harness.
Step 2. Replace the HDD harness.
Step 3. Replace the HDD.
Step 4. Replace the SYS board.
Replace the HDD.
Replace the HDD.
Number of USB device connections
(NG will not be displayed)
Number of fax connections
(NG will not be displayed)
Replace the SYS board.
Step 1. Check the installation status of
CN132 on the SYS board and the
corresponding connector on the LGC
board.
Step 2. Replace the harness connected
to CN132
Step 3. Replace the LGC board.
Step 4. Replace the SYS board.
Step 1. Check the installation status of
CN131 and CN132 on the SYS board
and the corresponding connector on the
LGC board.
Step 2. Replace the harness connected
to CN131 and CN132 in sequence
Step 3. Replace the LGC board.
Step 4. Replace the SYS board.
Step 1. Update scanner firmware.
Step 2. Replace the SYS board.
Replace the SYS board.
Refer to C260 Troubleshoot of service
manual and check each item.
Refer to C261 Troubleshoot of service
manual and check each item.
Refer to C262 Troubleshoot of service
manual and check each item.
Refer to C270 Troubleshoot of service
manual and check each item.