Philips AZ 2045 매뉴얼 - 페이지 5

{카테고리_이름} Philips AZ 2045에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Philips AZ 2045 8 페이지. Cd soundmachine
Philips AZ 2045에 대해서도 마찬가지입니다: 사용자 설명서 (9 페이지), 사용자 설명서 (15 페이지), 사양 (2 페이지), 사용자 설명서 (12 페이지), 서비스 매뉴얼 (34 페이지), 매뉴얼 (10 페이지), (스웨덴어) Snabbmanual (8 페이지)

Philips AZ 2045 매뉴얼
English
TOP AND FRONT PANELS
(See 1)
1SOURCE – selects CD/ TUNER / TAPE function
2y – power on/ off switch
3Display – shows the status of the set
4Cassette recorder keys
RECORD 0 – starts recording
PLAY 2 – starts playback
SEARCH 5/6 – fast winds/rewinds tape
STOP/OPEN 9/
– opens the cassette compartment
– stops the tape
PAUSE ; – pauses playback or recording
5BASS, MID, HIGH – EQ keys to adjust the bass,
mid & treble frequencies
6PROG
CD:
programmes tracks and reviews the
programme;
Tuner: programmes preset radio stations
Navigation controls
7∞, §
CD:
– searches back and forward within a
track;
– skips to the beginning of a current
track/ previous/ later track
Tuner: – tunes to radio stations (down, up).
82; – starts or pauses CD playback
99 – stops CD playback;
– erases a CD programme
0MODE – selects different play modes:
e.g.
or
(random) order
REPEAT
SHUFFLE
!PUSH TO OPEN – opens/closes the CD door
@VOLUME – to adjust volume level
#REMOTE SENSOR (for AZ2055 model only) –
infrared sensor for remote control
$PRESET DOWN/ UP (–, +) – selects a preset
tuner station (down, up)
%BAND – selects waveband
^DBB – (Dynamic Bass Boost) activates a more
vivid bass response
CONTROLS
BACK PANEL
&Telescopic aerial – improves FM reception
*Battery compartment – for 6 batteries,
type R-20, UM1 or D-cells
(p – 3.5 mm stereo headphone socket
Note: The speakers will be muted when
headphones are connected to the set.
)AC MAINS – inlet for mains lead
REMOTE CONTROL (for AZ2055 only)
1VOLUME 3,4 – adjusts volume level (up, down)
2SHUFFLE – plays all CD tracks in random order
32; – starts/ pauses CD playback
4SEARCH 5, 6 – searches backwards/ forwards
within a track
5PRESET +, – – selects a preset radio station
(up, down)
6TUNING ∞, § – tunes to tuner stations
(down, up)
79 – stops CD playback;
– erases a CD programme
8¡, ™ – skips to the beginning of a current track
previous/ subsequent track
9REPEAT – repeats a track /programme/ entire CD
CAUTION
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
IMPORTANT!
For users in the U.K.: please follow the instructions on
the upper righthand-side.
BASIC FUNCTIONS
MAINS SUPPLY
Whenever convenient, use the mains supply to
conserve battery life. Make sure you remove the
power plug from the set and wall socket before
inserting batteries.
Batteries (not included)
• Insert 6 batteries, type R-20, UM-1 or D-cells,
(preferably alkaline) with the correct polarity.
Remote control (for AZ2055 only /See A)
• Insert 2 batteries, type AAA, R03 or UM4
(preferably alkaline).
Incorrect use of batteries can cause electrolyte
leakage and will corrode the compartment or cause
the batteries to burst.
• Do not mix battery types: e.g. alkaline with carbon
zinc. Only use batteries of the same type for the
set.
• When inserting new batteries, do not try to mix old
batteries with the new ones.
• Batteries contain chemical substances, so
they should be disposed of properly.
Using AC Mains
1 Check if the mains supply, as shown on the type
plate located on the bottom of the set,
corresponds to your local mains supply. If it does
not, consult your dealer or service centre.
2 If your set is equipped with a voltage selector,
adjust the selector so that it matches with the
local mains.
3 Connect the mains lead to the wall socket.
4 To disconnect the mains supply, unplug the set
from the wall socket.
Auto-Standby mode
When a CD or tape has reached the end of playback
and remains in the stop position for more than
15 minutes, the set will switch off automatically to
save mains.
The type plate is located on the bottom of the
set.
BASIC FUNCTIONS
Switching on and off and selecting function
1 Press y on the set to switch on.
2 Press SOURCE once or more to select:
,
CD
or
function.
TAPE
3 Press y to switch off the set.
Notes:
– To change from
to
or
function, or
TAPE
TUNER
CD
when you are switching off the set: first, make
sure you press the tape STOP 9 key to end
playback and all the cassette keys are released.
– The tone, sound settings, tuner presets and the
volume level (up to a maximum volume level of 20)
will be retained in the set's memory.
Adjusting volume and sound
1 Adjust the volume with the VOLUME control.
™ Display shows the volume level and a number
from 0-32. (See 2)
2 Press DBB once or more to select dynamic bass
boost on or off.
™ Display: shows
when activated.
3 To adjust the bass, mid and treble tones, press and
hold + or – on the BASS, MID, HIGH keys until
you reach the desired level, –5 to +5
™ Display briefly shows
,
, or
BASS
MID
HIGH
level. (See 3)
Note: To prevent sound interference the bass control
options operate exclusively. You cannot combine the
bass from BASS with DBB
™ The display shows
or the
indicator is
automatically switched off to remind you if you
attempt to use both bass settings.
TUNER
and the