Toshiba IntranetFax 운영자 매뉴얼 - 페이지 11

{카테고리_이름} Toshiba IntranetFax에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba IntranetFax 22 페이지. Direct smtp

TopAccess Setup

Setup on the TopAccess menu is required before the IntranetFax function can be used.

 Setting up the DNS session

If you are using the fully qualified domain name (FQDN) of the MFP for a destination Email address in the IntranetFax

function, set up the DNS session in advance.

For details of the DNS session, see the following:

TopAccess Guide "Chapter 8 [Administration] Tab Page - [Setup] Item List - Network settings - Setting up DNS Session"

 Setting up the DDNS session

If you are using Dynamic DNS service (DDNS), set up the DDNS session in advance.

For details of the DDNS session, see the following:

TopAccess Guide "Chapter 8 [Administration] Tab Page - [Setup] Item List - Network settings - Setting up DDNS

Session"

 Setting up the SMTP client

"Enable SMTP Client", "Maximum Email / InternetFax Size" and "Port Number" must be set for the SMTP client in

advance.

For details of the SMTP client setup, see the following:

TopAccess Guide "Chapter 8 [Administration] Tab Page - [Setup] Item List - Network settings - Setting up SMTP Client"

 When the IntranetFax function is enabled, "Enable SSL", "SSL/TLS", "POP Before SMTP" and "Authentication"

settings are not used. However, the setting are used for email transmission.

 Be sure to enable "Enable SMTP Client".

 Setting up the SMTP server

"Enable SMTP Server","Port Number" and "Email Address" must be set for the SMTP server in advance. For the format of

the Email address, see  P.10 "Email Address Format".

For details of the SMTP server setup, see the following:

TopAccess Guide "Chapter 8 [Administration] Tab Page - [Setup] Item List - Network settings - Setting up SMTP Server"

 Setting up InternetFax

In the InternetFax settings, enter a destination Email address for the IntranetFax in the From Address field. For the format

of the Email address, see  P.10 "Email Address Format". Then set "Number of Retry" and "Retry interval" as required.

Number of Retry:

Retry interval:

For details of the InternetFax settings, see the following:

TopAccess Guide "Chapter 8 [Administration] Tab Page - [Setup] Item List - InternetFax settings - Setting up InternetFax

Setting"

Enter the desired number from 0 to 14 for retrying a failed IntranetFax transmission.

Enter the desired interval from 0 to 15 for retrying a failed IntranetFax transmission (unit: minutes).

2 INTRANETFAX CONFIGURATION