Philips BTD7170 사용자 설명서 - 페이지 13

{카테고리_이름} Philips BTD7170에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Philips BTD7170 32 페이지.
Philips BTD7170에 대해서도 마찬가지입니다: 사용자 설명서 (32 페이지)

페이지 인쇄

Switch to standby mode

Press

again to switch the unit to standby

mode.

» The clock (if set) is displayed on the panel.

Switch to ECO standby mode:

Press and hold

for more than two seconds.

» The display panel is dimmed.

Note

•

The unit switches to Eco Power Standby mode after 3

hours in standby mode.

Switch between standby mode and ECO

standby mode:

Press and hold

for more than two seconds.

Find the correct viewing

channel

Press SOURCE repeatedly to select the

DISC source.

Turn on the TV and switch to the correct

video-in channel in one of the following

ways:

• Go to the lowest channel on your TV,

and then press the Channel Down

button until you see the blue screen.

• Press the source button repeatedly on

the remote control of your TV.

Tip

•

The video-in channel is between the lowest and highest

channels and may be called FRONT, A/V IN, VIDEO etc.

See the TV user manual on how to select the correct

input on the TV.

Select the correct TV system

Change this setting if the video is not displayed

correctly. By default, this setting matches the

most common setting for TVs in your country.

Press .

Select [Setup] -> [Video] -> [TV System].

Select a setting and press OK.

• [PAL]- For TV with PAL color system.

• [Multi]- For TV that is compatible with

both PAL and NTSC.

• [NTSC]- For TV with NTSC color

system.

To return to the previous menu, press

To exit the menu, press .

Change system menu

language

Press .

Select [Setup] -> [General] -> [OSD

Language], and press OK.

Select a setting and then press OK.

To exit the menu, press .

Set up EasyLink (HDMI-CEC

control)

This home theater supports Philips EasyLink,

which uses the HDMI-CEC (Consumer

Electronics Control) protocol. EasyLink-

compliant devices that are connected through

HDMI can be controlled by a single remote

control.