Philips DCM 278 사용자 설명서 - 페이지 13

{카테고리_이름} Philips DCM 278에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Philips DCM 278 18 페이지. Sleek micro sound system
Philips DCM 278에 대해서도 마찬가지입니다: 사용자 설명서 (22 페이지), 사용자 설명서 (19 페이지), 사용자 설명서 (21 페이지), 빠른 시작 매뉴얼 (3 페이지), 빠른 시작 매뉴얼 (4 페이지), 빠른 시작 매뉴얼 (3 페이지), 빠른 시작 매뉴얼 (3 페이지), 설치 지침 (1 페이지), 사양 (3 페이지), 사양 (3 페이지), 사양 (3 페이지)

페이지 인쇄
Philips DCM 278 사용자 설명서

6 Listen to radio

Tune to a radio station

1
Press TUNER to select FM.
2
Press and hold
seconds.
» SEARCH] (search) is displayed.
[
»
The radio tunes to a station with
strong reception automatically.
3
Repeat step 2 to tune to more stations.
•
To tune to a weak station, press
repeatedly until you find optimal
reception.
Program radio stations
automatically
You can program a maximum of 20 preset
radio stations (FM).
1
In the tuner mode, press and hold PROG/
CLOCK SET for more than 2 seconds to
activate automatic program mode.
» AUTO] (auto) is displayed.
[
»
All available stations are programmed
in the order of waveband reception
strength.
»
The first programmed radio station is
broadcast automatically.
Program radio stations
manually
You can program a maximum of 20 preset
radio stations (FM).
1
Tune to a radio station.
2
Press PROG/CLOCK SET to activate
program mode.
» PROG] (program) is displayed.
[
14
EN
/
for more than 2
3
Press / to allocate a number to this
radio station, then press PROG/CLOCK
SET to confirm.
4
Repeat the above steps to program other
stations.
Tip
•
To overwrite a programmed station, store
another station in its place.

Select a preset radio station

/
1
In tuner mode, press / to select a
preset number.
Tip
•
Position the antenna as far as possible from
TV, VCR or other radiation source.
•
For optimal reception, fully extend and adjust
the position of the antenna.

FM stations with RDS

Radio Data System (RDS) is a service that
sends additional broadcast information along
with FM stations.
If you listen to a FM station with RDS signal,
"RDS" is displayed.
Display RDS information
1
For an FM station with RDS, press
RDS/DISPLAY repeatedly to display
various broadcast information.