Toshiba TLP-ET1U 소유자 매뉴얼 - 페이지 40

{카테고리_이름} Toshiba TLP-ET1U에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba TLP-ET1U 50 페이지. 3lcd projector

Maintenance

Air filter cleaning

The air filter prevents dust and debris from getting inside the projector. Never run the projector with the filter

removed. The air filter should be cleaned regularly.

• The

icon message, "Check the air filter for dirt," is displayed every 100 hours. (If the usage time exceeds 100

hours, this message is displayed for 30 seconds when the image is displayed for the first time after the power is

turned on. The message will be dismissed with any operation.)

• Check out the filter and, if any debris is found, use the following procedure for cleaning.

• Request cleaning and maintenance of a ceiling-mounted unit to your projector dealership.

Unplug the power cord.

Remove the air filter.

Clean the filter.

Replace the air filter.

Notes

• Allowing dirt and dust to build up in the air filter will worsen the air circulation inside the projector, causing the

internal temperature to rise, the projector to stop working or malfunction.

• Insert the air filter all the way in. Leaving gaps will allow dust and dirt to get inside the projector again.

• If the air filter is torn, consult with your dealer about replacing it with a new one. Continuing to use a ripped

filter will allow dust and dirt to get inside the projector.

Pull out the air filter by taking the catch shown in the figure with

your fingertips.

After turning the projector over, place it carefully. It is

recommended to lay a soft cloth, such as a thick towel, under the

unit to prevent it from shaking or getting scratched.

Carefully remove the dust and dirt from the air filter with a

vacuum cleaner or the like.