Epson WorkForce 600 Series 기능 설명서 - 페이지 23

{카테고리_이름} Epson WorkForce 600 Series에 대한 기능 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson WorkForce 600 Series 28 페이지. Using the control panel for wireless network installation
Epson WorkForce 600 Series에 대해서도 마찬가지입니다: 네트워크 설치 매뉴얼 (41 페이지), 사용자 설명서 (34 페이지), 사용자 설명서 (38 페이지), 카트리지 교체 (2 페이지), 중요한 설정 정보 (2 페이지), 사양 (2 페이지), 여기에서 시작하기 매뉴얼 (9 페이지), 제품 지원 게시판 (5 페이지)

The printer does not appear in the Add Printer window (Mac OS X)

Make sure the printer driver was installed correctly and that your computer's

TCP/IP settings are configured correctly.

Printing Problems

Cannot print over the network

■

Print a Network Status Sheet (see page 25) and verify that the network

settings are correct.

■

When using TCP/IP, make sure the printer's IP address is set correctly for your

network. If your network does not assign IP addresses using DHCP, you will

need to set the IP address manually.

■

Print a Network Status Sheet (see page 25). If the Link Status says Disconnect,

make sure that the wireless router or access point is turned on and that the

settings are correct for your wireless network.

■

Reset the printer's network settings (see page 26) and perform a first-time

installation of the printer and software (see page 3).

Printing is slow or the print is cut off

Print a Network Status Sheet (see page 25) and check the Signal Condition. If it's

poor, try moving the printer closer to your wireless router or access point. Avoid

placing the printer next to a microwave oven, 2.4 GHz cordless phone, or large

metal object such as a filing cabinet.

A dial-up connection dialog box appears when printing with EpsonNet

If you use a dial-up connection for Internet access, you will see this message every

time you print. Try connecting to the Internet using a LAN connection or set your

dial-up connection to dial manually (Never dial a connection).

Troubleshooting