3Com WL-464 설치 매뉴얼 - 페이지 4

{카테고리_이름} 3Com WL-464에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com WL-464 8 페이지. 802.11a mini-pci radio module

4.2. Antenna module side:

1 Align the antenna module with the snaps and posts on the unit and press until the

module snaps firmly into place.

2 Align the cables to be routed through the slots in the unit.

3 After the cables are aligned, press them down out of the way inside the housing.

Replace the back cover.

Make sure that the cables are tucked away inside the housing so that they do not obstruct

the cover. Align the back cover with the unit and settle the cover into place. Tighten the

four screw.

Attach the antennas.

Being careful not to touch the antenna tips, screw the antennas onto the SMA connectors

and hand tighten them. After network startup , you may need to adjust the antennas to

fine tune radio coverage.

Reinstall the access point.

Reconnect the Ethernet cable and reattach the access point to the wall mounting plate.

Adjust the antennas to improve the radio signal, if necessary.