3Com WL-464 Instrukcja instalacji - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Bezprzewodowy punkt dostępowy 3Com WL-464. 3Com WL-464 8 stron. 802.11a mini-pci radio module
Drukuj stronę4.2. Antenna module side:
1 Align the antenna module with the snaps and posts on the unit and press until the
module snaps firmly into place.
2 Align the cables to be routed through the slots in the unit.
3 After the cables are aligned, press them down out of the way inside the housing.
5
Replace the back cover.
Make sure that the cables are tucked away inside the housing so that they do not obstruct
the cover. Align the back cover with the unit and settle the cover into place. Tighten the
four screw.
6
Attach the antennas.
Being careful not to touch the antenna tips, screw the antennas onto the SMA connectors
and hand tighten them. After network startup , you may need to adjust the antennas to
fine tune radio coverage.
7
Reinstall the access point.
Reconnect the Ethernet cable and reattach the access point to the wall mounting plate.
Adjust the antennas to improve the radio signal, if necessary.