3Com 3C892 - OfficeConnect ISDN Lan Modem Router 설정 - 페이지 6

{카테고리_이름} 3Com 3C892 - OfficeConnect ISDN Lan Modem Router에 대한 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com 3C892 - OfficeConnect ISDN Lan Modem Router 14 페이지. Setting up the isdn lan modem on a static network
3Com 3C892 - OfficeConnect ISDN Lan Modem Router에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (8 페이지)

페이지 인쇄

ISDN LAN M

ETTING

P THE

TCP/IP Setup Using

Windows 3.11

A S

ODEM

TATIC

ETWORK

6 You are then prompted to insert your installation CD-ROM. Insert the Windows

NT 4.0 CD ROM and then click Continue.

If you have Remote Access Service (RAS) installed on your PC after the

appropriate ﬁles are copied to your PC, a message box asks whether or not you

would like TCP/IP installed for RAS. If you select Yes, you must select the device

you want to access remotely and then click Close.

7 After the appropriate ﬁles are copied to your PC, you will see TCP/IP Protocol

listed in the Network Protocols group box, as shown in Figure 8.

Figure 8 Network Protocols Window

8 Click Close.

The Microsoft TCP/IP Properties window appears.

9 From the Adapter drop down list box, select the Ethernet card that is connected

to the ISDN LAN modem.

10 For static IP addresses, Specify an IP Address should be selected and an IP

address and subnet mask for your computer should be entered. (You can obtain

this information from your system administrator or ISP.)

11 Click OK.

12 Click Yes to restart your PC and allow the changes to take effect.

If you are using Windows 3.11, a TCP/IP stack is not provided as part of the

operating system. If you do not have a TCP/IP stack, you can use MS _TCP

which is provided on the 3Com Companion Programs CD-ROM.

Setting up TCP/IP Using MS TCP

To set up MS_TCP, do the following.

1 Install MS_TCP, located on the 3Com Companion Programs CD-ROM, onto your

hard drive.