3Com 3C892 - OfficeConnect ISDN Lan Modem Router 설정
{카테고리_이름} 3Com 3C892 - OfficeConnect ISDN Lan Modem Router에 대한 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com 3C892 - OfficeConnect ISDN Lan Modem Router 14 페이지. Setting up the isdn lan modem
on a static network
3Com 3C892 - OfficeConnect ISDN Lan Modem Router에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (8 페이지)
페이지 인쇄
Installing the ISDN
LAN Modem
S
U
ETTING
O
A S
N
TATIC
This note describes how to configure the ISDN LAN modem on a static
network. If you have not determined whether your network is static, refer to
the Getting Started Guide.
If you have not already installed the ISDN LAN modem, refer to the diagram
while following the steps.
T
S E
R E
C
V D
4
1 8
1 0 -
A X
A M
0 • 8
Before you begin, power down the computer you will connect to your ISDN
LAN modem.
Insert one end of the Ethernet cable into a 10BASE-T LAN port and then
1
connect the opposite end of the Ethernet cable to your computer's Ethernet
port.
Caution: Only connect one computer to the ISDN LAN modem until after
you have finished the configuration process. After configuration, you can
connect any additional computers and/or printers which you would like to
add to your LAN. Also, do not connect the ISDN LAN modem to an existing
LAN.
Connect the RJ-45 (8-pin) connector end of the RJ-45/RJ-11cable labeled
2
ISDN to the port labeled ISDN and then connect the other end to the RJ-11
ISDN wall jack.
If you are connecting analog equipment, connect one end of an RJ-11 cable
3
(provided with your analog device) into one of the RJ-11 modular jacks
ISDN LAN M
P THE
N
ETWORK
N
2
I S D
1
2
N
L A
1
3
4
2
E
O N
P H
1
3
ODEM