3Com 3C892 - OfficeConnect ISDN Lan Modem Router Налаштування
Переглянути онлайн або завантажити pdf Налаштування для Модем 3Com 3C892 - OfficeConnect ISDN Lan Modem Router. 3Com 3C892 - OfficeConnect ISDN Lan Modem Router 14 сторінок. Setting up the isdn lan modem
on a static network
Також для 3Com 3C892 - OfficeConnect ISDN Lan Modem Router: Посібник для початківців (8 сторінок)
Друкувати сторінку
Installing the ISDN
LAN Modem
S
U
ETTING
O
A S
N
TATIC
This note describes how to configure the ISDN LAN modem on a static
network. If you have not determined whether your network is static, refer to
the Getting Started Guide.
If you have not already installed the ISDN LAN modem, refer to the diagram
while following the steps.
T
S E
R E
C
V D
4
1 8
1 0 -
A X
A M
0 • 8
Before you begin, power down the computer you will connect to your ISDN
LAN modem.
Insert one end of the Ethernet cable into a 10BASE-T LAN port and then
1
connect the opposite end of the Ethernet cable to your computer's Ethernet
port.
Caution: Only connect one computer to the ISDN LAN modem until after
you have finished the configuration process. After configuration, you can
connect any additional computers and/or printers which you would like to
add to your LAN. Also, do not connect the ISDN LAN modem to an existing
LAN.
Connect the RJ-45 (8-pin) connector end of the RJ-45/RJ-11cable labeled
2
ISDN to the port labeled ISDN and then connect the other end to the RJ-11
ISDN wall jack.
If you are connecting analog equipment, connect one end of an RJ-11 cable
3
(provided with your analog device) into one of the RJ-11 modular jacks
ISDN LAN M
P THE
N
ETWORK
N
2
I S D
1
2
N
L A
1
3
4
2
E
O N
P H
1
3
ODEM