Dimplex Opti-myst 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Dimplex Opti-myst에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex Opti-myst 3 페이지. Wall engine
Dimplex Opti-myst에 대해서도 마찬가지입니다: 사용자 설명서 (13 페이지), 매뉴얼 (17 페이지), 매뉴얼 (16 페이지)

페이지 인쇄

Changing a

Transducer

Switch the fire off on the unit and at the mains.

Remove the fuel bed, water bottle and the nozzle assembly

by twisting the red twist clips either side (left hand clockwise

& right hand anticlockwise) or push release clips on the front

of the nozzle assembly. IMAGE 1.

Unplug the old transducer. IMAGE 2.

Place the new transducer into the sump, ensuring that the

transducer is correctly placed – the tab on the transducer

should be lined up with the moulded recess in the sump

and the unit should be sitting flat. IMAGE 3.

Join the cable to the connector on the sump on the right

hand side. IMAGE 4.

Ensure that the cable is not placed above the disc on the

transducer unit. IMAGE 5.

To prevent the cable becoming pinched between the nozzle

and the sump, place the cable in the provided slot in the

right hand side wall of the sump. IMAGE 5.

Replace the sump nozzle and secure it by turning the two

red/black tabs by 90 degrees (left hand anti clockwise and

right hand clockwise, or clicked back into place if your fire

has the push fit clips. IMAGE 6.

Once everything has been put back together, please wait

for 5 minutes before turning the fire back on at the mains

and at the fire. This will allow the fire to reset and allow

the fire to function correctly.

Scan here to watch our video

"How to change a transducer" online