Aeon Labs AEO_SES3_EU 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Aeon Labs AEO_SES3_EU에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeon Labs AEO_SES3_EU 5 페이지. Inline smart energy switch

페이지 인쇄

Load will be closed when the Current overrun (US: 15.5A, other country: 16.2A) and the time more than 2 minutes (0=disabled, 1=enabled).

Value

Active Overload Protection (Default)

Deactivate Overload Protection

Output Load Status (Parameter Number 20, Parameter Size 1)

Configure the output load status after re‐power on.

Value

Notification on Status Change (Parameter Number 80, Parameter Size 1)

Defines the automated status notification of an associated device when status changes (0=nothing, 1=hail CC, 2=basic CC report).

Value

Configure the state of red LED (Parameter Number 81, Parameter Size 1)

Value

The LED will follow the status (on/off) of its load. (Default)

When the state of Switch's load changed, The LED will follow the status (on/off) of its load, but the red LED will turn off after 5 seconds if there is no any switch action.

Enables/disables parameter 91/92 (Parameter Number 90, Parameter Size 1)

Value

Enabled parameter 91/92 (Default)

Disabled parameter 91/92

Minimum Change to send Report (Watt) (Parameter Number 91, Parameter Size 2)

The value represents the minimum change in wattage for a Report to be sent .

Value

0 — 32000

The value represents the minimum change in wattage. (Default 25)

Minimum Change to send Report (%) (Parameter Number 92, Parameter Size 1)

The value represents the minimum change in wattage Percent for a report to be sent. (Valid values 0‐100)

Value

0 — 100

The value represents the minimum change in wattage Percent. (Default 5)

Set 101‐103 to default (Parameter Number 100, Parameter Size 1)

Value

Report type send in Reporting Group 1 (Parameter Number 101, Parameter Size 4)

Defines the type of report sent for the Reporting Group 1.

Value

Report Type send in Reporting Group 2 (Parameter Number 102, Parameter Size 4)

Defines the type of report sent for the Reporting Group 2.

last status (Default)

always on

always off

nothing (Default)

hail

basic CC report

set to default (Default)

nothing

Multisensor Report

Meter Report for Watt

Meter Report for kWh (Default)

Description