Aeon Labs Aeotec MULTISENSOR 6 사용자 설명서 - 페이지 3

{카테고리_이름} Aeon Labs Aeotec MULTISENSOR 6에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeon Labs Aeotec MULTISENSOR 6 11 페이지.
Aeon Labs Aeotec MULTISENSOR 6에 대해서도 마찬가지입니다: 매뉴얼 (14 페이지)

페이지 인쇄
Aeon Labs Aeotec MULTISENSOR 6 사용자 설명서
2/26/2018
1. Remove your sensor's rear cover as shown in the previous step.
2. Insert two CR123A batteries orientated according to the diagram within your sensor. Your MultiSensor 6 is now powered on.
Note: MultiSensor 6 can be powered by a single CR123A, though batteries will require changing more frequently. If powering your
MultiSensor 6 with a sole battery, insert it into the battery holder marked 1.
WARNING: Not compatible to rechargeable CR123A batteries (3.7V)
Adding your MultiSensor 6 into a Z-Wave Network.
With it powered on, it's now time to add your MultiSensor 6 to a Z-Wave network. To pair Multisensor 6, you are not limited to only the
Z-Stick or Minimote. You may use any Z-Wave Gateway to pair Multisensor 6, but compatibility and how the sensor shows ultimately
depends on the gateway and software integration of products.
If you're using a Z-Stick from Aeotec:
https://aeotec.freshdesk.com/support/solutions/articles/6000057073-multisensor-6-user-guide-
MultiSensor 6 user guide. : Aeotec by Aeon Labs
3/11