Aeon Labs Aeotec MULTISENSOR 6 Посібник користувача - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник користувача для Аксесуари Aeon Labs Aeotec MULTISENSOR 6. Aeon Labs Aeotec MULTISENSOR 6 11 сторінок.
Також для Aeon Labs Aeotec MULTISENSOR 6: Посібник (14 сторінок)
Друкувати сторінку
2/26/2018
1. Remove your sensor's rear cover as shown in the previous step.
2. Insert two CR123A batteries orientated according to the diagram within your sensor. Your MultiSensor 6 is now powered on.
Note: MultiSensor 6 can be powered by a single CR123A, though batteries will require changing more frequently. If powering your
MultiSensor 6 with a sole battery, insert it into the battery holder marked 1.
WARNING: Not compatible to rechargeable CR123A batteries (3.7V)
Adding your MultiSensor 6 into a Z-Wave Network.
With it powered on, it's now time to add your MultiSensor 6 to a Z-Wave network. To pair Multisensor 6, you are not limited to only the
Z-Stick or Minimote. You may use any Z-Wave Gateway to pair Multisensor 6, but compatibility and how the sensor shows ultimately
depends on the gateway and software integration of products.
If you're using a Z-Stick from Aeotec:
https://aeotec.freshdesk.com/support/solutions/articles/6000057073-multisensor-6-user-guide-
MultiSensor 6 user guide. : Aeotec by Aeon Labs
3/11