Dimplex RKHA 매뉴얼 - 페이지 2

{카테고리_이름} Dimplex RKHA에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex RKHA 4 페이지. Under cabinet heater
Dimplex RKHA에 대해서도 마찬가지입니다: 설치 지침 (2 페이지), 소유자 매뉴얼 (3 페이지), 사용 설명서 (10 페이지), 매뉴얼 (4 페이지)

페이지 인쇄

2. Cut 22 ⅜ in (568 mm) x 3 ⅝ in (92 mm) opening

(Figure 2). Keep clearance area free of obstructions.

3. Bring in service cable to left or rear of 10 in (254 mm)

minimum area as shown in Fig. 2.

4. Remove heater cover and appropriate knockout.

Attach service cable to unit with approved connector

and connect colour to colour in outlet box. To change

wattage or voltage connections, see Figure 5.

5. Replace cover, slide unit into opening, and secure

each side (Figure 1).

NOTE: Make sure unit is installed right side up.

Refer to "TOP" label.

For inspection of field wiring, see instruction under

"Electrical Inspection".

Soffit or Stair Riser Installation

1. Cut opening as for heater installation (22 ⅜ in

(568 mm) x 3 ⅝ in (92 mm)). Allow ¾ in (19 mm)

clearance below cabinet doors. Add supports for unit

(Figure 3).

2. Proceed as for heater installation. After securing unit

in opening, install combination of frame and grille

(Figure 1).

Operation

WARNING: This heater must be properly installed

before it is used.

1. Prior to energization remove all construction dirt

(plaster, sawdust, etc.) from interior and exterior of

heater.

2. Adjust thermostat with pliers. This unit is also

controllable from a line voltage wall thermostat or

field installed built-in tamperproof single or double

pole thermostat kit.

Dimplex Under Cabinet heaters are designed and tested

for safe and trouble-free operation and are protected

against overheating by a built-in thermal cutout. Free

airflow throughout the heater is extremely important for

the most efficient operation of the heater. Restricted

airflow may cause the thermal overload protector to

cycle the heater "ON and OFF". A cycling heater will not

supply sufficient heat to the room.

Avoid direct contact of paper, fabric, or furniture with

heater.

FIGURE 1

Heater Cover

Top Label

Junction Box Cover

Screw 'C'

Screw 'A'

FIGURE 2

10" MIN.

Service

SERVICE

Cable

CABLE

22"

KNOCKOUTS

Knockouts

FIGURE 3

CEILING

GRILLE

HEATER

CABINET

DOOR

FIGURE 4

CABINET

DOOR

HEATER

GRILLE

FLOOR

Heater

Element

Screw'B'

Grille

Optional Grille Frame

22-3/8"

22 3/8"

3 5/8"

3-5/8"

3-1/2"

3 1/2"

9-1/2"

9 1/2"

CLEARANCE 5" MIN.

3/4"

MIN.

PARTITION

OR ADDED

SUPPORT

PARTITION

OR ADDED

3/4

SUPPORT

MIN.