Dimplex XLS12N 설치 지침 매뉴얼 - 페이지 7
{카테고리_이름} Dimplex XLS12N에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex XLS12N 8 페이지. Ultra-slim storage heaters
Dimplex XLS12N에 대해서도 마찬가지입니다: 사용 설명서 (10 페이지), 운영 지침 (4 페이지), 설치 지침 매뉴얼 (8 페이지), 운영 지침 (4 페이지), 설치 지침 매뉴얼 (8 페이지)
페이지 인쇄
23. Position the bottom rear layer of bricks with the recess
over the slots in the base insulation slab. Push the bricks
firmly to the back of the heater, then fit the top row of
bricks.
25. Fit the front bricks with the airways facing inwards.
27. Check that the damper mechanism within the heater
functions freely, by rotating the left hand control knob.
Check also that the right hand (input) knob rotates freely.
24. Replace the element which had been removed by
carefully passing the ends through the base insulation
slots into the terminal blocks below. Position the insulator
on the element end in contact with the terminal block
ceramic as shown, and tighten the connection screws. At
this point check that all element connections are tight.
26. Re-fit the inner front panel/insulation assembly,
ensuring the bottom edge of the panel is located behind the
base flange. Make sure all screws removed in Operation
19 are replaced securely.
28. Introduce mains supply cable through the cable clamp
into the terminal area, and connect in accordance with the
terminal markings. HEAT RESISTING CABLE MUST BE
USED (min. T85). Ensure that the cable is clamped so
that there is no excess cable in the terminal area. ON
NO ACCOUNT SHOULD ANY SURPLUS CABLE BE
PUSHED INSIDE OR BEHIND THE HEATER. CHECK
ALL ELECTRICAL CONNECTIONS FOR TIGHTNESS.