Dimplex XLS12N Manual de instruções de instalação - Página 7

Procurar online ou descarregar pdf Manual de instruções de instalação para Aquecedor elétrico Dimplex XLS12N. Dimplex XLS12N 8 páginas. Ultra-slim storage heaters
Também para Dimplex XLS12N: Manual de Instruções (10 páginas), Instruções de utilização (4 páginas), Manual de instruções de instalação (8 páginas), Instruções de utilização (4 páginas), Manual de instruções de instalação (8 páginas)

23. Position the bottom rear layer of bricks with the recess

over the slots in the base insulation slab. Push the bricks

firmly to the back of the heater, then fit the top row of

bricks.

25. Fit the front bricks with the airways facing inwards.

27. Check that the damper mechanism within the heater

functions freely, by rotating the left hand control knob.

Check also that the right hand (input) knob rotates freely.

24. Replace the element which had been removed by

carefully passing the ends through the base insulation

slots into the terminal blocks below. Position the insulator

on the element end in contact with the terminal block

ceramic as shown, and tighten the connection screws. At

this point check that all element connections are tight.

26. Re-fit the inner front panel/insulation assembly,

ensuring the bottom edge of the panel is located behind the

base flange. Make sure all screws removed in Operation

19 are replaced securely.

28. Introduce mains supply cable through the cable clamp

into the terminal area, and connect in accordance with the

terminal markings. HEAT RESISTING CABLE MUST BE

USED (min. T85). Ensure that the cable is clamped so

that there is no excess cable in the terminal area. ON

NO ACCOUNT SHOULD ANY SURPLUS CABLE BE

PUSHED INSIDE OR BEHIND THE HEATER. CHECK

ALL ELECTRICAL CONNECTIONS FOR TIGHTNESS.