Aeon Labs KeyFob 매뉴얼 - 페이지 3

{카테고리_이름} Aeon Labs KeyFob에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeon Labs KeyFob 5 페이지. Z-wave

Once this is done the Key Fob will work as the primary controller and as a remote control within the Z-Wave network.

Group Mode

When using the Key Fob in Group Mode you are able to control different Z-Wave devices with each of your remote's 4 buttons. In

Group Mode each button is capable of controlling up to 50 Z-Wave devices.

For association do the steps as descriped in the chapter assiciotions.

Now you can control the Z-Wave devices you have associated with the Key Fob. By pushing the particular button the device will

not only switch on or off, but it is to the level you selected in the earlier steps. With the Key Fob you have a further funcion to

control multi-level devices. By holding a button for a particular device on the Key Fob the button will send up and down

instructions to any compatible device. Holding the button of a dimmable light will dim the brightness up or down.

In order to disassociate devices with the Key Fob do the same steps like associating.

Scene Mode

When using your Key Fob in the Scene Mode you are able to control multiple Z-Wave devices with each of the 4 buttons of the

remote. In Scene Mode each button is capable of controlling two scenes. Each scene can contain 1 to 5 Z-Wave devices. Use your

gateway to configure scenes in the Z-Wave network.

Every of the 4 action buttons can control 2 scenes. To use the primary scene single click on the button. To use the secondary

scene press and hold the button for 2 seconds and release it. The numbering of the scenes (shown in the picture) is important to

configure the scenes with your gateway.

Node Information Frame

NIF

The Node Information Frame is the business card of a Z-Wave device. It contains information about the device type and the

technical capabilities. The inclusion and exclusion of the device is confirmed by sending out a Node Information Frame. Beside this

it may be needed for certain network operations to send out a Node Information Frame.

A single click at the "Learn" button for 5 seconds sends a Node Information Frame.