Aeon Labs KeyFob 매뉴얼 - 페이지 4

{카테고리_이름} Aeon Labs KeyFob에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeon Labs KeyFob 5 페이지. Z-wave

Special Functions as Z-Wave Controller

As long as this device is not included into a Z-Wave network of a different controller it is able to manage its own Z-Wave network

as primary controller. As a primary controller the device can include and exclude other devices in its own network, manage

associations, and reorganize the network in case of problems. The following controller functions are supported:

Include other device in own network

Communication between two Z-Wave devices only works if both belong to the same wireless network. Joining a network is

called inclusion and is initiated by a controller. The controller needs to be turned into the inclusion mode. Once in this inclusion

mode the other device needs to confirm the inclusion - typically by pressing a button.

When your Key Fob is setup as the primary controller in the Z-Wave network it's able to add and remove devices in the network.

Inclusion

Bring your Key Fob in the Setup Mode.

Take your Key Fob to within 3 meters of the device you wish to control.

Slide open the main panel of your Key Fob and press the Include button. The green LED will blink. If the red LED lights up for 2

seconds the Key Fob is set as secondary controller in the Z-Wave network and it is notable to add or remove devices in the

network.

Press the dedicated button on the device you wish to add.

When the device was succesfully included the green LED on the Key Fob will light up for 2 seconds and then begin to blink

again. If the device wasn't succesfully added, the red LED will light up for 2 seconds and then begin to blink again.

Repeat the steps to include further Z-Wave devices.

Once you have finished, press any button on the Key Fob to exit the inclusion mode.

If current primary controller in your network is in special SIS mode this and any other secondary controller can also include and

exclude devices.

To become primary a contoller have to be resetted and then include a device.

Exclude device from network

The primary controller can exclude devices from the Z-Wave network. During exclusion the relationship between the device and

the network of this controller is terminated. No communication between the device and other devices still in the network can

happen after a successful exclusion. The controller needs to be turned into the exclusion mode. Once in this exclusion mode the

other device needs to confirm the exclusion - typically by pressing a button.

Attention: Removing a device from the network means that it is turned back into factory default status. This process can also

exclude devices from it's previous network.

Exclusion

Bring your Key Fob in the Setup Mode.

Take your Key Fob to within 3 meters of the device you wish to control.

Slide open the main panel of your Key Fob and press the Remove button. The red LED will blink. If the red LED lights up for 2

seconds the Key Fob is set as secondary controller in the Z-Wave network and it is notable to add or remove devices in the

network.

Press the dedicated button on the device you wish to remove.

When the device was successfully excluded the green LED on the Key Fob will light up for 2 seconds and then the red LED

begins to blink. If the device wasn't succesfully removed, the red LED will light up for 2 seconds and then begin to blink again. In

this case repeat the process from step 1 again.

Repeat the steps to exclude further Z-Wave devices.

Once you have finished, press any button on the Key Fob to exit the exclusion mode.