Aeon Labs Aeotec Z-Stick Gen5 매뉴얼 - 페이지 8
{카테고리_이름} Aeon Labs Aeotec Z-Stick Gen5에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeon Labs Aeotec Z-Stick Gen5 17 페이지. Z-wave usb adapter
Aeon Labs Aeotec Z-Stick Gen5에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (11 페이지)
페이지 인쇄
gateway. To do this, please refer to the part of their respective
manuals that tell you how to remove devices from your network.
1.
Put your primary controller into device removal mode.
2.
Unlock your Sensor from the Back Mount plate and take the
Sensor unit near to your primary controller.
3.
Press the Action Button on your Sensor.
4.
If your Door Window Sensor has been successfully removed
from your Z-Wave network, its Status LED will fast blink for 8
seconds and then slow blink for 3 seconds when you press
the Action Button again. If the removing was unsuccessful,
the Status LED will fast blink for 2 seconds and then be solid
for 2 seconds when you press the Action Button, repeat the
above steps.
Security or Non-security feature of your Sensor in Z-
Wave network.
Including Door/Window Sensor as a non-secure device:
If you want your Sensor as a non-security device in your Z-
Wave network, you just need to press the Action Button once
on Door Window Sensor when you use a controller/gateway
to add/include your Sensor.
Including Door/Window Sensor as a secure device:
In order to take full advantage of all functionality the Door
Window Sensor, you may want your Sensor is a security
device that uses secure/encrypted message to communicate in
Z-Wave network, so a security enabled controller/gateway is
needed for the Door Window Sensor to be used as a
security device.