Aeon Labs Aeotec Z-Stick Gen5 Посібник - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник для Адаптер Aeon Labs Aeotec Z-Stick Gen5. Aeon Labs Aeotec Z-Stick Gen5 17 сторінок. Z-wave usb adapter
Також для Aeon Labs Aeotec Z-Stick Gen5: Посібник із швидкого старту (11 сторінок)
Друкувати сторінку
gateway. To do this, please refer to the part of their respective
manuals that tell you how to remove devices from your network.
1.
Put your primary controller into device removal mode.
2.
Unlock your Sensor from the Back Mount plate and take the
Sensor unit near to your primary controller.
3.
Press the Action Button on your Sensor.
4.
If your Door Window Sensor has been successfully removed
from your Z-Wave network, its Status LED will fast blink for 8
seconds and then slow blink for 3 seconds when you press
the Action Button again. If the removing was unsuccessful,
the Status LED will fast blink for 2 seconds and then be solid
for 2 seconds when you press the Action Button, repeat the
above steps.
Security or Non-security feature of your Sensor in Z-
Wave network.
Including Door/Window Sensor as a non-secure device:
If you want your Sensor as a non-security device in your Z-
Wave network, you just need to press the Action Button once
on Door Window Sensor when you use a controller/gateway
to add/include your Sensor.
Including Door/Window Sensor as a secure device:
In order to take full advantage of all functionality the Door
Window Sensor, you may want your Sensor is a security
device that uses secure/encrypted message to communicate in
Z-Wave network, so a security enabled controller/gateway is
needed for the Door Window Sensor to be used as a
security device.