Pioneer AppRadio SPH-DA01 설치 매뉴얼 - 페이지 15

{카테고리_이름} Pioneer AppRadio SPH-DA01에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer AppRadio SPH-DA01 40 페이지. Display unit appradio
Pioneer AppRadio SPH-DA01에 대해서도 마찬가지입니다: 운영 매뉴얼 (32 페이지), 운영 매뉴얼 (36 페이지), 사용자를 위한 중요 정보 (24 페이지), 펌웨어 업데이트 (4 페이지)

페이지 인쇄

1. Connecting the Power Cord and the Speaker Cable

Installation

Installation using the screw

holes on the side of this product

% Fastening the unit to the factory radio-

mounting bracket.

Position this product so that its screw holes

are aligned with the screw holes of the brack-

et, and tighten the screws at three or four loca-

tions on each side.

Use either the truss head screws (5 mm ×

6 mm) or flush surface screws (5 mm ×

7 mm), depending on the shape of the brack-

et's screw holes.

If the tab interferes with installation,

you may bend it down out of the way.

Factory radio-mounting bracket

Truss head screw

or flush surface

screw

Be sure to use the

screws supplied

with this product.

Dashboard or console

Installing the GPS antenna

CAUTION

Do not cut the GPS antenna lead to shorten

it or use an extension to make it longer. Alter-

ing the antenna cable could result in a short

circuit or malfunction and permanent da-

mage to this product.

Installation notes

! The antenna should be installed on a level

surface where radio waves will be blocked

as little as possible. Radio waves cannot be

received by the antenna if reception from

the satellite is blocked.

Dashboard

! Take care not to pull the antenna lead when

removing the GPS antenna. The magnet at-

tached to the antenna is very powerful, and

the lead may become detached.

! Do not paint the GPS antenna, as this may

affect its performance.

Parts supplied

GPS antenna

Section

Rear shelf

Double-sided tape