Pioneer AppRadio SPH-DA01 Руководство по установке - Страница 15
Просмотреть онлайн или скачать pdf Руководство по установке для Автомобильный приемник Pioneer AppRadio SPH-DA01. Pioneer AppRadio SPH-DA01 40 страниц. Display unit appradio
Также для Pioneer AppRadio SPH-DA01: Руководство по эксплуатации (32 страниц), Руководство по эксплуатации (36 страниц), Важная информация для пользователя (24 страниц), Обновления прошивки (4 страниц)
Печатать страницу
Installation
Installation using the screw
holes on the side of this product
% Fastening the unit to the factory radio-
mounting bracket.
Position this product so that its screw holes
are aligned with the screw holes of the brack-
et, and tighten the screws at three or four loca-
tions on each side.
Use either the truss head screws (5 mm ×
6 mm) or flush surface screws (5 mm ×
7 mm), depending on the shape of the brack-
et's screw holes.
If the tab interferes with installation,
you may bend it down out of the way.
Factory radio-mounting bracket
Truss head screw
or flush surface
screw
Be sure to use the
screws supplied
with this product.
Dashboard or console
Installing the GPS antenna
CAUTION
Do not cut the GPS antenna lead to shorten
it or use an extension to make it longer. Alter-
ing the antenna cable could result in a short
circuit or malfunction and permanent da-
mage to this product.
Installation notes
! The antenna should be installed on a level
surface where radio waves will be blocked
as little as possible. Radio waves cannot be
received by the antenna if reception from
the satellite is blocked.
Dashboard
! Take care not to pull the antenna lead when
removing the GPS antenna. The magnet at-
tached to the antenna is very powerful, and
the lead may become detached.
! Do not paint the GPS antenna, as this may
affect its performance.
Parts supplied
GPS antenna
Section
Rear shelf
Double-sided tape
15
En
03