Pioneer AVIC-U310BT 설치 매뉴얼 - 페이지 6

{카테고리_이름} Pioneer AVIC-U310BT에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer AVIC-U310BT 45 페이지. Flash memory navigation audio receiver
Pioneer AVIC-U310BT에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 브로셔 (9 페이지), 중요 정보 매뉴얼 (38 페이지)

페이지 인쇄

Section

Connecting the System

Before installing this product

! This product is for vehicles with a 12-volt

battery and negative grounding. Check the

battery voltage of your vehicle before instal-

lation.

! To avoid shorts in the electrical system, be

sure to disconnect the (–) battery cable be-

fore beginning installation.

To prevent damage

WARNING

! When replacing the fuse, be sure to only

use a fuse of the rating prescribed on this

product.

! When disconnecting a connector, pull the

connector itself. Do not pull the lead, as

you may pull it out of the connector.

! This product cannot be installed in a vehi-

cle without ACC (accessory) position on

the ignition switch.

ACC position

! To avoid short-circuiting, cover the discon-

nected lead with insulating tape. It is espe-

cially important to insulate all unused

speaker leads, which if left uncovered may

cause a short circuit.

No ACC position

! Attach the connectors of the same color to

the corresponding colored port, i.e., blue

connector to the blue port, black to black,

etc.

! Refer to the owner's manual for details on

connecting the power amp and other units,

then make connections accordingly.

! Since a unique BPTL circuit is employed,

do not directly ground the * side of the

speaker lead or connect the * sides of the

speaker leads together. Be sure to connect

the * side of the speaker lead to the *

side of the speaker lead on this navigation

system.

! Never connect speakers with an output rat-

ing of less than 50 W channel or impe-

dance outside of the 4 ohms to 8 ohms

specifications to your navigation system.

Connecting speakers with output and/or

impedance values other than those noted

here may result in the speakers catching

fire, emitting smoke, or becoming da-

maged.

Notice for the blue/white lead

! When this unit is turned on, a control sig-

nal is output through the blue/white cable.

Connect it to an external power amp's sys-

tem remote control or the vehicle's auto-an-

tenna relay control terminal (max. 300 mA,

12 V DC). If the vehicle is equipped with a

glass antenna, connect the cable to the an-

tenna booster power supply terminal.

! Never connect the blue/white cable to an

external power amp's power terminal. Also,

never connect it to the power terminal of

the auto antenna. Otherwise, battery drain

or malfunction may result.