AeonAir WDH-945EL-1 사용자 설명서 - 페이지 7

{카테고리_이름} AeonAir WDH-945EL-1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AeonAir WDH-945EL-1 15 페이지.

페이지 인쇄

OPERATING INSTRUCTIONS (cont'd)

CONTINUOUS DRAIN (garden hose to be purchased separately)

The function of continuous drain can be performed using the

following steps:

1. To save having to periodically empty the water tank, this unit can

be confgiured for continuous drain. You can use the garden hose

to connect to the continuous drain connector (garden hose to be

purchased separately)

2. Unscrew and remove the drain cover at the rear of the unit (Fig.

A).

3. Remove the soft rubber stopper, and place it in the water tank for

safe keeping (Fig. B).

4. Ensure the rubber seal ring is properly seated in the end of the

hose as shown in Fig. C.

5. Connect the garden hose to the drain port (Fig. D).

6. Tighten the garden hose in clockwise direction onto the rear of

the unit (Fig. D).

7. Place the bucket in its original location (Fig. E).

8. Place the other end of the garden hose to your floor drain.

Fig. A

Fig. B

Drain cover

(Garden hose

to be purchased

separately)

The above method is for floor drain hole drainage.

Gravity feed drain

Fig. C

Rubber seal ring

to be purchased

separately)

Fig. D

(Garden hose

to be purchased

separately)

Fig. E

Soft rubber

Bucket

stopper

Drain cover

AeonAir.com

CARE AND MAINTENANCE

CLEANING

CAUTION:

disconnect the power supply cord from the electrical supply outlet.

1) DO NOT use gasoline, benezene. paint thinner, or any other chemicals to clean this unit, as

2) Never attempt to clean the unit by pouring water directly over any of the surface areas, as this

will cause deterioration of electrical components and wiring insulation.

3) Use only a mild dish washing detergent, lukewarm water, and a soft cloth to wipe the exterior

surface of the unit and dry thoroughly.

STORAGE

(Garden hose

When the dehumidifer is not being used for long time periods, please follow these instructions:

1) Disconnect the power cord from the power supply.

2) Empty the water tank and wipe (dry) thoroughly.

4) Re-package the unit in the original carton.

5) Store the unit upright in a dry location.

TROUBLESHOOTING

Occasionally, you may encounter some problems that are of a minor nature and a service call

may not be necessary. Use this troubleshooting guide to identify possible problems you may be

experiencing.

PROBLEM

1) Unit will not operate.

2) Dehumidifying capacity

(moisture removal) low.

3) Relative Humidity setting not

reached after long period of operation.

POSSIBLE CAUSE

• Check power cord connection.

• Check electrical outlet for blown fuse.

• Check if water tank is full (if yes, empty).

• Check water tank is properly installed.

• Relative humidity in surrounding environment very low.

• Check all doors and windows are closed.

AeonAir.com