AeonAir WDH-945EL-1 Podręcznik użytkownika - Strona 7
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Osuszacz powietrza AeonAir WDH-945EL-1. AeonAir WDH-945EL-1 15 stron.
Drukuj stronę
OPERATING INSTRUCTIONS (cont'd)
CONTINUOUS DRAIN (garden hose to be purchased separately)
The function of continuous drain can be performed using the
following steps:
1. To save having to periodically empty the water tank, this unit can
be confgiured for continuous drain. You can use the garden hose
to connect to the continuous drain connector (garden hose to be
purchased separately)
2. Unscrew and remove the drain cover at the rear of the unit (Fig.
A).
3. Remove the soft rubber stopper, and place it in the water tank for
safe keeping (Fig. B).
4. Ensure the rubber seal ring is properly seated in the end of the
hose as shown in Fig. C.
5. Connect the garden hose to the drain port (Fig. D).
6. Tighten the garden hose in clockwise direction onto the rear of
the unit (Fig. D).
7. Place the bucket in its original location (Fig. E).
8. Place the other end of the garden hose to your floor drain.
Fig. A
Fig. B
Drain cover
(Garden hose
to be purchased
separately)
The above method is for floor drain hole drainage.
Gravity feed drain
Fig. C
Rubber seal ring
to be purchased
separately)
Fig. D
(Garden hose
to be purchased
separately)
Fig. E
Soft rubber
Bucket
stopper
Drain cover
AeonAir.com
12
CARE AND MAINTENANCE
CLEANING
CAUTION:
disconnect the power supply cord from the electrical supply outlet.
1) DO NOT use gasoline, benezene. paint thinner, or any other chemicals to clean this unit, as
2) Never attempt to clean the unit by pouring water directly over any of the surface areas, as this
will cause deterioration of electrical components and wiring insulation.
3) Use only a mild dish washing detergent, lukewarm water, and a soft cloth to wipe the exterior
surface of the unit and dry thoroughly.
STORAGE
(Garden hose
When the dehumidifer is not being used for long time periods, please follow these instructions:
1) Disconnect the power cord from the power supply.
2) Empty the water tank and wipe (dry) thoroughly.
4) Re-package the unit in the original carton.
5) Store the unit upright in a dry location.
TROUBLESHOOTING
Occasionally, you may encounter some problems that are of a minor nature and a service call
may not be necessary. Use this troubleshooting guide to identify possible problems you may be
experiencing.
PROBLEM
1) Unit will not operate.
2) Dehumidifying capacity
(moisture removal) low.
3) Relative Humidity setting not
reached after long period of operation.
TM
POSSIBLE CAUSE
• Check power cord connection.
• Check electrical outlet for blown fuse.
• Check if water tank is full (if yes, empty).
• Check water tank is properly installed.
• Relative humidity in surrounding environment very low.
• Check all doors and windows are closed.
AeonAir.com
13
TM