Pioneer SPH-10BT 펌웨어 업데이트 지침 - 페이지 2

{카테고리_이름} Pioneer SPH-10BT에 대한 펌웨어 업데이트 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer SPH-10BT 4 페이지. Smartphone receiver
Pioneer SPH-10BT에 대해서도 마찬가지입니다: 설치 매뉴얼 (33 페이지), 운영 매뉴얼 (35 페이지), 펌웨어 업데이트 지침 (6 페이지), 시스템 펌웨어 업데이트 지침 (7 페이지)

페이지 인쇄

B. Downloading the Firmware Update File

Download the correct file from the website to a folder on your computer.

MODEL

SPH-10BT

C. Create the System Firmware Update USB memory device:

USB memory device requirements:

- USB specification 2.0 and 128 MB or more in capacity

- Should be blank (should not contain any files) and formatted in FAT32

PROCEDURE:

1. Connect the USB memory device to your computer.

2. Double click the ZIP file named "

3. Extract and save the file named "19DEH_A0817.scd" to a folder on your computer

4. Copy the firmware file "19DEH_A0817.scd" to the USB memory device. Ensure that the

update file is located within the root (top folder) of your USB storage device. There should

be no other files on the USB storage device.

5. Confirm that the file name and file size are correct on the USB memory device. To check

the file size in Microsoft Windows, select the file, press the right mouse button, and select

"Properties". If the file name and size do not match the ones listed above, perform steps

A and B again.

NOTE:

If the correct file is not copied to the USB memory device, your unit will not recognize it as an

update USB memory device and you will not be able to carry out the update.

D. Updating the Firmware on Your Unit

REMARKS:



Please DO NOT perform this firmware update if the model number of your Pioneer unit is

anything other than the above listed model.



While your unit is being updated, DO NOT turn off the system's power, DO NOT touch the

unit's buttons, DO NOT remove the front panel and DO NOT remove the USB storage device

during the firmware update process, as this may result in severe damage to your unit.



Make sure to disconnect all external mobile devices connected to your unit.



The update process takes approximately 6 minutes to complete.

PROCEDURE:

1. Start the vehicle engine.

2. Connect the USB storage device to the USB input on your unit.

3. If AV Source is On, Press and hold

DOWNLOAD

_A0817.zip

SPH-10BT

SOURCE/MUSIC/OFF

FIRMWARE

19DEH_A0817.scd

_A0817.zip" to open it.

button to switch off the source.

FIRMWARE SIZE

23.203.792 bytes

And