Pioneer SPH-10BT Ürün Yazılımı Güncelleme Talimatları - Sayfa 2
Araç Alıcısı Pioneer SPH-10BT için çevrimiçi göz atın veya pdf Ürün Yazılımı Güncelleme Talimatları indirin. Pioneer SPH-10BT 4 sayfaları. Smartphone receiver
Ayrıca Pioneer SPH-10BT için: Kurulum Kılavuzu (33 sayfalar), Kullanım Kılavuzu (35 sayfalar), Ürün Yazılımı Güncelleme Talimatları (6 sayfalar), Sistem Ürün Yazılımı Güncelleme Talimatları (7 sayfalar)
Sayfayı Yazdır
B. Downloading the Firmware Update File
Download the correct file from the website to a folder on your computer.
MODEL
SPH-10BT
C. Create the System Firmware Update USB memory device:
USB memory device requirements:
- USB specification 2.0 and 128 MB or more in capacity
- Should be blank (should not contain any files) and formatted in FAT32
PROCEDURE:
1. Connect the USB memory device to your computer.
2. Double click the ZIP file named "
3. Extract and save the file named "19DEH_A0817.scd" to a folder on your computer
4. Copy the firmware file "19DEH_A0817.scd" to the USB memory device. Ensure that the
update file is located within the root (top folder) of your USB storage device. There should
be no other files on the USB storage device.
5. Confirm that the file name and file size are correct on the USB memory device. To check
the file size in Microsoft Windows, select the file, press the right mouse button, and select
"Properties". If the file name and size do not match the ones listed above, perform steps
A and B again.
NOTE:
If the correct file is not copied to the USB memory device, your unit will not recognize it as an
update USB memory device and you will not be able to carry out the update.
D. Updating the Firmware on Your Unit
REMARKS:
Please DO NOT perform this firmware update if the model number of your Pioneer unit is
anything other than the above listed model.
While your unit is being updated, DO NOT turn off the system's power, DO NOT touch the
unit's buttons, DO NOT remove the front panel and DO NOT remove the USB storage device
during the firmware update process, as this may result in severe damage to your unit.
Make sure to disconnect all external mobile devices connected to your unit.
The update process takes approximately 6 minutes to complete.
PROCEDURE:
1. Start the vehicle engine.
2. Connect the USB storage device to the USB input on your unit.
3. If AV Source is On, Press and hold
DOWNLOAD
_A0817.zip
SPH-10BT
SPH-10BT
SOURCE/MUSIC/OFF
FIRMWARE
19DEH_A0817.scd
_A0817.zip" to open it.
button to switch off the source.
FIRMWARE SIZE
23.203.792 bytes
And