Pioneer Super Tuner IIID DEH-P7100BT 설치 매뉴얼 - 페이지 2

{카테고리_이름} Pioneer Super Tuner IIID DEH-P7100BT에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer Super Tuner IIID DEH-P7100BT 43 페이지. Cd rds receiver
Pioneer Super Tuner IIID DEH-P7100BT에 대해서도 마찬가지입니다: 보충 설명서 (2 페이지), 브로셔 (9 페이지), 설치 매뉴얼 (7 페이지), 빠른 시작 매뉴얼 (9 페이지)

페이지 인쇄
Pioneer Super Tuner IIID DEH-P7100BT 설치 매뉴얼
Contents
Connecting the units ............................. 2
Connecting the power cord ............................ 4
separately sold power amp ........................ 8
Installation ............................................ 10
DIN Front/Rear-mount ................................... 10
Removing or attaching the trim ring .................... 10
DIN Front-mount .................................................... 11
DIN Rear mount ..................................................... 11
Fastening the front panel .............................. 12
Installing the microphone ............................. 12
on the sun visor ................................................. 12
on the steering column ..................................... 13
Adjusting the microphone angle .......................... 13
2

Connecting the units

Note
• When this unit is installed in a vehicle without
ACC (accessory) position on the ignition switch,
red cable must be wired to the terminal that can
detect the operation of the ignition key. Otherwise,
battery drain may result.
ACC position
• Use this unit in other than the following
conditions could result in fire or malfunction.
- Vehicles with a 12-volt battery and negative
grounding.
- Speakers with 50 W (output value) and 4 ohm
to 8 ohm (impedance value).
• To prevent short-circuit, overheating or
malfunction, be sure to follow the directions
below.
- Disconnect the negative terminal of the
battery before installation.
- Secure the wiring with cable clamps or
adhesive tape. To protect the wiring, wrap
adhesive tape around them where they lie
against metal parts.
- Place all cables away from moving parts, such
as gear shift and seat rails.
- Place all cables away from hot places, such as
near the heater outlet.
- Do not pass the yellow cable through a hole
into the engine compartment to connect to a
battery.
- Cover any disconnected cable connectors with
insulating tape.
- Do not shorten any cables.
- Never cut the insulation of the power cable of
this unit in order to share the power to other
equipment. Current capacity of the cable is
limited.
- Use a fuse of the rating prescribed.
- Never wire the speaker negative cable directly
to ground.
- Never band together multiple speaker's
negative cables.
No ACC position